01894-1 Briggs and Stratton Generator - Overview

It is a genuine manufacturer-supplied item that is specially designed for Snapper, Briggs and Stratton and Troy-Bilt pressure washers. This is one of the wheels that support the equipment and allow for easy transportation. The wheel kit provides an identical replacement for a damaged or a missing part that was installed on a new equipment...Read more. It is a high-quality kit which includes the wheel, the washer, and the E-clip to secure it. Note, pliers and a wrench will be needed to replace this component.

This is an OEM part sourced directly from the manufacturer. The bearing carrier is commonly found in generators from Briggs & Stratton and Snapper. This part is made of metal, and is used to hold one end of the stator assembly and the brush holder. You will require a wrench when replacing this item. This product is sold with a flexible rubber O-ring.

This brush holder assembly is an authentic OEM replacement part that is specially designed for use on Briggs and Stratton generators. Brushes help to conduct electric current in the motor that powers the unit. This assembly includes one plastic brush holder and two carbon brushes with a lead wires and springs attached. You would need a screwdriver to complete this job.

This authentic replacement part is specially designed for Briggs and Stratton generators. It is supplied from the original equipment manufacturer. This is an important component of the unit which regulates the voltage. Over time it may develop electrical or mechanical issues eventually requiring a replacement. This high-quality component ...Read moreis sold as an individual item. Make sure to refer to the owners manual and the diagrams of your model for the exact location and the correct application of this regulator. You will need a screwdriver and a wrench set to remove the housing in order to perform this repair.

This item is available as an individual replacement part. The outlet is made out of metal and plastic. It may require a wrench during installation. This item will need to be replaced if it breaks. It is a replacement part directly sourced from the manufacturer for use in generators made by Briggs & Stratton and Snapper.

Keep in mind that this high-quality part is made of metal and is sold individually. A set of pliers might be helpful during the installation of this part. The e-ring fits onto the wheel and will need to be replaced if it breaks. It is a genuine OEM sourced part which is specially designed for use with generators and pressure washers made by Briggs & Stratton, Troy-Bilt, and Snapper.