01773-0 Briggs and Stratton Generator - Overview

This replacement flange nut is an authentic manufacturer-sourced component which is specially designed for use with Briggs and Stratton equipment. It is the hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate for the correct location and use of this part. Keep in mind this du...Read morerable metal nut is sold individually, you will need a wrench to secure or remove it.

This item is available as an individual replacement part. The outlet is made out of metal and plastic. It may require a wrench during installation. This item will need to be replaced if it breaks. It is a replacement part directly sourced from the manufacturer for use in generators made by Briggs & Stratton and Snapper.

The vibration mount is made out of metal. It is a genuine Briggs & Stratton and Snapper replacement part used in compatible generators. This item is available as an individual replacement part. A screwdriver might be required during the replacement of this part. This part may become broken or bent and will need to be replaced.

This is an original Briggs & Stratton replacement part. The screw is designed by the manufacturer for use in generators. This part is made of metal, and is generally used in securing the bearing cover. Please be aware that there are different screws used in the machine. Refer to the parts diagram to be sure of ordering the correct par...Read moret. You will require a wrench when replacing this item. This part is sold individually.

This is a genuine OEM sourced replacement part designed for use with generators. This assembly includes a plastic brush holder, two (2) carbon brushes with a lead wires and springs attached. Carbon brushes are a commonly replaced part on power tools. Due to normal use and friction brushes will gradually wear down and will require replace...Read morement. It is advised to replace both brushes at the same type. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • First remove the cover and gain access to the brush assembly • Take our old brushes and replace them with the new ones • Reassembly the cover