01058-0 Briggs and Stratton Pressure Washer - Overview
Sections of the 01058-0
[Viewing 1 of 1]
Keep searches simple, eg. "belt" or "pump".
Gasket-crkcse/009
PartSelect #: PS8937085
Manufacturer #: 270896
This is a genuine replacement part that is OEM sourced to be used with lawnmower engines from Briggs & Stratton and Toro. The gasket is used to seal the connection between the body of the crankcase an...
$10.95
Special Order
Seal-o Ring
PartSelect #: PS8936675
Manufacturer #: 270344S
This authentic OEM replacement part fits a variety of Toro and Briggs & Stratton engines. An O ring is used to retain pressure between rigid parts. Its flexible material allows it to create a tight se...
$5.95
In Stock
Key-flywheel
PartSelect #: PS8925657
Manufacturer #: 222698S
This is a Genuine OEM replacement part used on a variety of Lawn and Garden equipment. The key helps to secure Flywheel in place. This is a Metal Key and it is Sold Individually. You would need Plier...
$5.95
In Stock
Rope-starter
PartSelect #: PS8945117
Manufacturer #: 280399S
This durable nylon starter rope is an authentic OEM supplied replacement part that is specially produced for use with Briggs and Stratton engines that are commonly installed on Toro lawn and garden eq...
$10.95
Special Order
Deflector-muffler
PartSelect #: PS8960984
Manufacturer #: 393760
This is a genuine Briggs & Stratton and Toro replacement part for use in engines, lawn mowers, and lawn tractors. The muffler deflector is made out of metal. A wrench may be needed during the replacem...
$15.95
Special Order
Screw
PartSelect #: PS9063630
Manufacturer #: 691061
This is an authentic OEM component from Briggs & Stratton. The magneto armature screw is compatible with many lawn and garden engines. The hardened metal screw helps to mount the magneto armature. A w...
$5.95
Special Order
Common Symptoms of the 01058-0
[Viewing 2 of 2]
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Muffler rusted out
-
Snoopy from TYRONE, GA
-
Difficulty Level:Very Easy
-
Total Repair Time:30 - 60 mins
7 of 18 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Had stripped thread had to rethread and install pump unloaded rebuild kit.
The reinstall was the hardest because the amount of tension with the spring. Had to cobble something together to hold spring tension until I got the new nut plug started. To bad you don’t give instructions and or tools to help with the actual install.
Parts Used:
-
Leonard from SAGINAW, MI
-
Difficulty Level:Very Difficult
-
Total Repair Time:More than 2 hours
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Push mower leaked under neath.
Pulled the old seal out, replaced it with seal #391483S and so far looking good !
Parts Used:
-
Raymond from Coalport, PA
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Socket set
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!