Makita Screwdriver Parts

This replacement urethane ring is a high quality item that is specially designed for Makita nailers. The purpose of this item is to create an air-tight seal for the pushing lever, for correct application make sure to check appropriate diagrams of your unit. Over time rings and seals will shrink, become brittle and crack eventually requiring a replacement. It is made from durable rubber and it is sold individually.

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with drywall screwdrivers. The metal gear is used to drive the spindle by interconnecting with the armature's gear. This item is sold as an individual replacement part.

This replacement pin is an authentic OEM component which is made for use with Makita equipment. The pin is generally utilized to secure a part while allowing it to rotate freely. It is a standard hardware which may have multiple applications. Make sure to refer to the appropriate diagrams of your model for the exact location and the correct installation of this pin. One durable metal item is included. You may need a screwdriver to take the unit apart when replacing this pin.

This is a Genuine OEM replacement part used on Makita drills and drivers. This is a metal spring and it is sold individually. Over time springs may lose its tension and may not function as intended. If this part is lost or damaged it must be replaced. To replace this spring a pair of pliers is needed.

This genuine Makita part is made by original manufacturer. This item fits drywall screwdrivers and other handheld power tools. Switch trigger is made of plastic material. Reversing switch lever is included in this part. This easy repair requires only a screwdriver to remove tool casing for switch installation.

Genuine Makita replacement part, this item is sold individually. This part is used on the tools listed below, to contain all of the part that are attached to the front end of the tool. Such as the Chuck assemblies on the the Impact Drivers and the Spindle Assemblies on the Screwdrivers.

This is a Genuine OEM replacement part used on some Makita Power Tools. This is a Metal Spring and it is Sold Individually. Over time springs may loose its tension and may not function as intended. If this part is lost or damaged it must be replaced.

This is a genuine Makita replacement part, it is sold individually. It is part of the bit holder. Without this Ball the bit would not stay in the holder. It is used in a number of different tools for different reasons. But it is most popular in Cordless Impact Drivers and Corded Screw Drivers. Compatible with the tools listed below. The diameter is 3.5mm.