Craftsman Generator Carburetors

Genuine manufacturer approved carburetor needle valve for lawn and garden equipment engines. This item includes the seat. The needle valve opens and closes to control the flow of fuel into the carburetor. Make sure to disconnect the spark plug wire and drain all gasoline from the carburetor and fuel tank before starting a repair.

This is an original Craftsman part for use with Lawn Mowers. The carburetor primer bulb circulates fuel to the carburetor to provide quicker starting. The most common reasons for replacing the primer bulb are when the engine leaks gas or won't start. This part is sold individually. The tools that you will need to replace the carburetor primer bulb is an 8mm socket or nut driver, small flat-head screwdriver and a Phillips-head screwdriver.

This choke link is an OEM direct from Briggs & Stratton. The metal component is made for use with many small engines. The choke link is fastened between the choke thermostat and the carburetor. This item helps to manage the air flow in the carburetor when the engine is activated. A hex key and a pair of pliers are often needed for the repair. The choke is sold individually.

Get your mower or generator running like new with this Briggs & Stratton carburetor. It mixes air and fuel so your engine runs smoothly and efficiently. If your engine is hard to start or losing power, replacing the carburetor is an easy way to boost performance and save fuel.

This is a genuine manufacturer-sourced part that is specially designed for use with Briggs and Stratton engines commonly installed on lawn and garden equipment. It is generally utilized to provide an air-tight seal for the carburetor, please make sure to check the diagrams of your model for the correct location and application of this hardware. Unfortunately, over time gasket material may deteriorate and crack eventually requiring replacement. This high-quality part is made of durable material and is sold individually.

This is an authentic manufacturer sourced carburetor float designed for use on lawn and garden equipment engines. This float controls fuel flow into the carburetor bowl by adjusting the needle valve. This float is sold individually. Please note the float pin is sold separately. To complete this repair you would need a wrench and pliers. • Make sure to remove the spark plug • Remove carburetor bowl • Remove old float and secure the new one in place • Re-assemble and test the unit