2784238892 Kenmore Wall Oven - Instructions

turn off power, remove 2 screws, lift off of hanger , slide out far enough to unplug wires. remove brackets from old element, I did have to use a screw driver to open up bracket to slide over new element(new element a little larger diameter coil) reverse removal. DONE !! Thank You Part Select !

Turned off the power. Removed two screws; removed element and unplugged two leads. Replaced elements and put element back in place. Simple as that. Oven now works great. I wish they were all that simple. But...the availability of parts for my 20+ YO oven made it all possible. The alternative was a new oven at more than $1000. Thank you PartSelect.

This repair was super easy. I removed the two screws holding the oven sensor in place, pulled the sensor from the oven wall to expose the two wires attached to the sensor cut and spliced in the new sensor as per instructions. The supplied wiring kit made this splice very easy. I then reinserted the wires and sensor from the oven wall, put the screws back in place tested the oven. Oven now works like new and I got bonus points from a happy wife!

The repair went ok. I did have to take the back off the stove in order to get to the wire connectors. Needed an extra person to move the stove out of it's location. Just had to be careful.

We were thinking we would have to buy anew oven at over 1000.00$ BOO!!!I found this place on line ordered the part and my husband easily fixed it!! Now we just need to find the clip to reattach the broiler!!! Thanks so much

When I got the part I removed the tin cover (two screws)on the back of the range. I removed the sensor by removing the two screws inside the oven and pulled out the sensor. taking the instructions advise, I checked the sensor with my ohm meter and although it read 1.1 ohms as compared with the recommended 1.09 ohms at room temperature in the instructions, went ahead and changed the unit. The connector did not fit my particular model so I spliced the wiring and using the two included wire nuts made the connection. I reinstalled the sensor, reattached the gas line, plugged it in and tried the oven before I put it back in place. The oven works great now and it was super easy.

shut off power to range, removed old element, looked up part on line, shopped for best price, Part select was $30 less than sears replacement part, ordered part, part arrived in 4 days, installed new part and I was broling again.

removed oven --removed back panel to disconnect sensor splice- installed new one. removed oven door --took it all apart--removed old gasket and installed new one.