Not Canadian? Click here to return to Partselect.com...
PartSelect Number PS884734
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
pulled the washer out and replaces the top roller system on both sides and the replaced the weels and brackets on the bottom drwaer. however i had trouble putting the dish washer back correctly and had to call a repairman to adjust the dishwasher and alighn it to open and close properly. but i did do good inside. i feel it was easy and a success. thank you for having the supplies for us to attempt to repair it on our own.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Inside the oven, I removed one Phillips screw on each side where the element mounts to the back oven wall. Then disconnected the wire on each side using pliers. Unscrewed glass lens, unscrewed light bulb. Replaced all pieces in reverse order. Took less than 10 minutes.
My Hotpoint gas stove was not operating at normal temperature. This was operating in a basic range of 125 - 100 degrees below normal. After going through numerous troubleshooting posts, I came to the conclusion the sensor was my first place to check. I did not want to drop $100 for a sensor if I did not need to, therefore, I decided that I needed to know how many ohms the sensor registered in my stove. The sensor need to be 1100 ohms and after using my digital multi-meter,( Analog meter would do for this job as well) sure enough the sensor did register 1100 ohms. I then started troubleshooting other components such as igniter, gas values, etc... All resulting in everything testing out good. That is what really puzzled me. Other posts of people having similar symptoms as my oven always came back to the sensor as the problem. Then I noticed that the cleaning temperature of the sensor needed to be 2600 ohms or somewhere in that range. Therefore, I heated up the oven and tested the temperature of the heated sensor and my sensor registered 1650 ohms. I concluded that the sensor tested good at room temperature, however when heated up, it was not registering correctly. I took a chance and purchased the senor, installed the sensor, which was quite easy and only reqired removing a few screws inside the stove, removal of back panel, and unconnecting the wire attachments, and the oven now operates as new, and just in time for Thanksgiving. The really great thing was that I was a hero in the eyes of my wife this Thanksgiving.
My husband replaced the bake element in moments. We couldn't get the broken light out of the socket because we couldn't locate our needle nose pliers. After a few days I finally got tired waiting and found a small pair of pliers in the house and got the remains of the bulb out and screwed it in, and plugged it in and we're in business!Never wait for a man to do what you can do yourself! I was so pleased that ordering the parts on-line was so easy and I didn't have an expensive repair bill to pay!
Everything was easy. I read one of your other reviews and it gave me the confidence to try it myself. First i toke off the cap at the top of the door then the three screws. I lifted the door off so i could be sure the cam was my only problem then put the door back on. That took 5 mins. Then I got on the computer and ordered the parts i needed. Two days later the parts arrived and and i took the door off again. Then put the new cam on, applied a litle vasiline, put the door back on and forgot that i ever had a problem. Thanks for the help. Doug Arau
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.