Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
John
March 12, 2023
The fan comes on when the door opens????
For model number PEM31SF2SS
Hi John, thank you for the question. We believe your microwave is having this issue because one of the door switches has failed and may need to be replaced. The part number for the interlock door switch is PS8753558. We hope this solves your problem!
Was this helpful?
Thank you for voting!
Barbara
May 10, 2023
The microwave doesn’t turn on lights work, key pad lights up, but no “microwave.
For model number PEM31SF2SS
Hi Barbara, thank you for contacting us. The problem seems to be with the diode and you may need to replace it, the part number is PS12342226. If the diode burns out, the magnetron will not receive enough voltage to operate, preventing the microwave from heating. We hope this sorts out your problem!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Slide a Butter knife at left side by open push knob door will open. Then open all screws from top cover push cover top side front way then door locks Bracket have 3 microswitch pulls out switches mark them top medium and bottom. Remove 3 screws holding brackets will come out. On bottom see a Cam has 1/4” holes can holding Saft broken then install new door lock bracket install microswitch put 3screw and slide Cam on saft . I put a small screw on saft to hold cam on place. There was no screw . That’s why cam saft was broke. Put top cover tight all the screws and door lock fixed.
I used small wire cutter I use in fly tying hobby. The metal was easy to cut. When cover was removed I unplugged the motor,removed it and plugged the new one in. To replace the cover -- reverse it,place the 2 tabs on one edge into the slots that are already part of the base. On the opposite edge there is a domed shaped tab with a hole in center. Place the small screw that was provided back in and thighten. Your Done