Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Dick
July 31, 2023
How do I remove the control unit?
For model number PEM31DF2WW
Hello Dick, thank you for your inquiry. Use the following instructions to replace the control unit:
1. Turn off the microwave.
2. Unthread the mounting screws securing the top grill.
3. Open the oven door and remove the grill.
4. Now, remove the control unit mounting screws.
5. Lift the control unit up and detach it.
6. Disconnect the wires connected to it.
We hope this information helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
John
April 7, 2024
what are the measurements
For model number PEM31DF2WW
Hello John, thank you for contacting us. According to our research, the dimensions of your model are approximately:
Height: 12 1/8 inches.
Width: 24 inches.
Depth:12 7/8 inches.
We hope this information helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Slide a Butter knife at left side by open push knob door will open. Then open all screws from top cover push cover top side front way then door locks Bracket have 3 microswitch pulls out switches mark them top medium and bottom. Remove 3 screws holding brackets will come out. On bottom see a Cam has 1/4” holes can holding Saft broken then install new door lock bracket install microswitch put 3screw and slide Cam on saft . I put a small screw on saft to hold cam on place. There was no screw . That’s why cam saft was broke. Put top cover tight all the screws and door lock fixed.
I used small wire cutter I use in fly tying hobby. The metal was easy to cut. When cover was removed I unplugged the motor,removed it and plugged the new one in. To replace the cover -- reverse it,place the 2 tabs on one edge into the slots that are already part of the base. On the opposite edge there is a domed shaped tab with a hole in center. Place the small screw that was provided back in and thighten. Your Done