This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
$10.20
In Stock
Order within the next 7 hrs and your part ships today!
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$26.51
In Stock
Order within the next 7 hrs and your part ships today!
This is a genuine replacement light bulb for a refrigerator. The inside of your refrigerator should illuminate when you open the door. If your fridge does not illuminate, you may need to replace this ...
$62.12
In Stock
Order within the next 7 hrs and your part ships today!
This temperature sensor is for refrigerators.
The temperature sensor senses the temperature inside the refrigerator and sends information to the electronic control.
Unplug the refrigerator and s...
$52.50
In Stock
Order within the next 7 hrs and your part ships today!
If your refrigerator or freezer is too warm, or making noises, you may need to replace the fan blade. The fan blade attaches to the evaporator motor, which is in the freezer section, to help circulate...
$47.43
In Stock
Order within the next 7 hrs and your part ships today!
Order within the next 7 hrs and your part ships today!
Questions And Answers for MZF34X20DW00
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Otto
January 4, 2023
want to buy a shelf for this freezer
For model number MZF34X20DW00
Hi Otto,
Thank you for your question. There are 2 wire shelves listed for your refrigerator. The part numbers for them are PS11731564 and PS10065540. If you need help placing an order for them, customer service is open 7 days a week and anyone will be happy to assist you. Please feel free to give us a call. We look forward to hearing from you!
Hi Guadalupe, thank you for reaching out. We would recommend checking the temperature sensor, part number PS11753994, and the capacitor, part number PS11753490. If this does not help, you can check the compressor, part number PS11703039. We look forward to hearing from you if you need assistance with placing an order through our 7-day-a-week customer service. We hope this helps!
I just replaced the thermostat inside the unit. Now when I set the temp on the middle setting the freezer goes into cooling mode. After it runs a while upon opening the door I see all 3 lights are on telling me it went into flash freeze on its own. I went thru the diagnostic checklist and everything looks good. Any ideas?
For model number MZF34X20DW00
Hi Gordon, thank you for asking. Since you have already replaced the thermostat, we would recommend checking the control box, part number PS12584186, to fix the issue. It houses the freezer temperature controls. We hope this helps, good luck with this repair!
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again.
An easy job for smaller hands. Removed the two bolts holding the light cover. Removed two electrical connections from the old switch by pinching the retaining clip,removed the switch, snapped in the new one and re-attached the connectors. Your online illustrations helped me to know that the plastic housing for the light switch would only swing down so far and was not intended to be removed. Saved me from breaking that plastic cover's tabs. This home repair saved me more than 5 times the cost of hiring a professional to do it. Very happy homeowner.
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great.