This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time. NOTE: This is a redesigned part. The pump now mounts on to the b...
$153.18
In Stock
Order within the next 4 hrs and your part ships today!
Also known as Thrust Bearing Kit. This kit includes the pulley, washer, thrust bearing, 2 upper race washers and 1 lower race washer. These parts are NOT available separately - they are ONLY availab...
$89.04
In Stock
Order within the next 4 hrs and your part ships today!
This package contains a new set of six springs. The suspension springs in your washer connect to the bottom of tub, and help to hold it in place. If your washer tub shakes, or moves around a lot durin...
$87.41
In Stock
Order within the next 4 hrs and your part ships today!
This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.
$11.68
In Stock
Order within the next 4 hrs and your part ships today!
I used a flat screw driver to push in on the releases so I could raise the top of the machine. I then used a torx tool to remove both parts of the hinge, and then used a #2 phillips screw driver, on the new screws I'd also ordered, to re-attach both of the hinge parts. Every thing went just as anticipated.
1)Start with empty washing machine. 2)Disconnect Hot, Cold, Power and Drain lines 3)Move machine to open area, open top by popping 2 front retaining clips. 4)Remove Front panel, remove small clear water level hose at lower rear of tub. 5)Remove small Rear access panel, disconnect large tub drain hose from pump and drain into small container, about 4 cups of water will come out. 5)Remove the 6 suspension Springs. 6)Place two large towels next to washer and tip machine onto its side slowly. 7)Remove drive belt from bottom, and slide out wash tub assembly thru top opening, be Careful not to damage large Plastic drive pulley on bottom of tub. 8)With tub upside-down, remove drive pully small plastic cover in center, remove E-Clip and remove pulley. 9)Slowly loosen snubber ring retaining bolts a few turns, DO NOT Remove, just loosen enough until snubber is free to move around. 10)Remove snubber ring by walking it around the retaining ring and install new snubber. 11) Clean machine cabinet and clean machine base where snubber touches with alcohol or Windex. 12) Reassemble in reverse order and Do Not Forget to reattach the small clear Water level sensing HOSE to the tub before closing the top. 13)Place Drive Belt onto the 2 small pulleys First, then slowly turn large pulley while walking belt onto it. 14)Reconnect machine to utilities and test run on small load to ensure no leaks and propper operation. 15)Enjoy Quiet free operation once again :)
back panel,belt two hoses,three screws, $100 dollars for the part!! pump is a molded part with a bearing insertion, is made in USA ! I'm guessing around 7 to 10 dollar manufacturing cost. I'm thinking that kind of mark-up is only exceded by the pharmacutical industry. I'm looking to buy a used machine for parts!!