The condenser fan blade fits onto the air conditioner motor shaft. The fan blade helps circulate air over the condenser to cool the refrigerant before it enters in to the evaporator. This part is beig...
$80.13
In Stock
Order within the next 3 hrs and your part ships today!
Unscrewed the unit from the exterior case pulled out the unit unscrewed the 4 screw that hold the fan shroud carefully unscrewed the coil pulled back unclipped the axial fan clip gentlyhit with rubber mallet replacement of new fan replaced clip 15 minutes best investment of 20 bucks as apposed to 400 $
PC Board #EBR895407 No Longer Available, replaced with #EBR7773051 - mirror image board, but wires long enough and connections same. Unit unplugged: slide filter up and out. Remove two phillips screws behind where top of filter was to remove grill (easier done with magnetic screw driver). Remove two phillips screws, one each side, at base of cabinet. Slide assembly out of cabinet 6-8". Remove phillips screw(s) on metal control panel housing. With needle nose, rock (2) main female spade connectors left/right until off (easier done with PC board still secured). Remove phillips screw holding plastic base of PC board. Viewing new board control connectors will simplify disconnecting the (3) control plugs. A small straight blade screwdriver can help.
