This part helps maintain a constant temperature within the appliance. The temperature control thermostat regulates the temperature inside the refrigerator. It turns on and shuts off the compressor as...
This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. The run capacitor is attached to the compressor. This part is 120 volts a...
This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.
This drawer slide supports the left or right hand side of the sliding drawer.
$45.60
In Stock
Questions And Answers for LFFH2067DW2
Ask our experts a question about this model and we'll get back to you as soon as possible!
7 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
RC
August 18, 2022
Have an 05 unit that gradually stopped maintaining freezing temp. Now looking for probable causes to help remedy
For model number LFFH2067DW2
Hi RC,
Thank you for your question. If your freezer is too warm, there are some parts that you will need to check to see which one is causing the issue. You will need to check the defrost thermostat, the defrost timer, the temperature control thermostat, the evaporator fan motor, the run capacitor and the door gasket. We have included some links that you may reference on how to check these parts. Once you have determined the part you need, please feel free to call customer service. We are open 7 days a week and anyone will be happy to assist you. We look forward to hearing from you!
Keeping water coming from somewhere and freezes in the bottom of the freezer. Where could the water be coming from?
For model number LFFH2067DW2
Hello Wayne, thank you for your question. The water might be backing up from the drain tube. There is a rubber tube under the fridge that drains the defrosted water from the unit into the evaporator pan under the appliance. We would recommend unplugging the unit, pull it out from the wall and locate the drain tube which is under the unit. Check for blockages of ice in that tube. I hope this helps.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Raymond
November 3, 2022
Freezer runs almost all the time. If I adjust the temperature to the warmest setting or off and on it shuts off. Temperature thermostat?
For model number LFFH2067DW2
Hello Raymond, thank you for contacting us. We would recommend cleaning the condenser coils and inspecting the door gasket to ensure an air-tight seal. Given that we are good here, the most probable cause of the issue is a faulty temperature control thermostat, part number PS12365300. Also, please ensure that the condenser and evaporator fans are running and there is no ice build-up in the freezer. In case you notice frost build-up, the issue can be related to the defrost thermostat, part number PS2350702. We look forward to hearing from you if you need assistance with placing an order through our 7-days-a-week customer service. We hope this helps!
My door has stopped suctioning shut. What part would I need to repair this?
For model number LFFH2067DW2
Hello Jerry, Thank you for your inquiry. We have researched the model number that you have provided and would recommend replacing the door gasket, part# PS11770643. Good luck with your repair.
What is causing my freezer door to not suction shut anymore. It used to suction after closing but it’s not working now. Please help.
For model number LFFH2067DW2
Hello Jerry, thank you for reaching out. The issue could be due to the door gasket being damaged. The gasket is used to seal the freezer door when closed. You may need to replace your gasket, part number PS11770643. We hope that helps!
This freezer has many screws that hold the cover on the back of the door and assist clamping the edge of the gasket in place. Be sure to just loosen the screws 3/4 the way out, use a flat head screw driver to pry the cover from the door in case over time it is stuck to the door. The new gasket will come in a creative box trying not to kink the gasket itself, but there will be some distortion of the gasket when you get it. Put it in the sun or in hot water. I put it in my dryer for 10 minutes. Remove the old gasket, and start at the top of the door to replace the gasket. TIPS: If the screws are backed out enough, there should not be any problem sliding the back part of the gasket under the cover. When on the sides, do not pull the gasket down to make it easier to slide the gasket underneath the cover. This will distort and lengthen the gasket so it will not fit and thin it out so it will not function well. Once the gasket is in place, tighten the screws being sure to feel along the outside edge of the gasket for any bulging that would indicate that portion of the gasket is NOT under the cover properly.
Turned gray knob on defrost timer (located bottom left back of freezer) past defrost position to verify compressor would run...it would not, but fan would run. Tested run capacitor...found borderline defective (weak, wrong value ohm meter kick). Just to be sure, removed interior shelves and interior rear and gasket to check heater at 20 ohms as OK and removed thermostat and verified contact closure after exposure in another freezer....re-installed, hooked heater back up and re-installed interior rear panel. Replaced defrost timer by unplugging 4-pin connector, then removed 2 screws that hold it to the bracket. Installed new one in reverse order. Then removed wire bail holding run capacitor to compressor plug assembly, removed run capacitor, plugged in new one. Turned on freezer......now making ice and holding cold temperature and cycling properly between freeze and defrost modes. Two problems made this repair a bit more difficult. This is the second time that defrost timer has failed...only got 3 years from last one.
I accidently threw away both freezer keys to our upright Gibson and G.E. Freezers!!!! I had no luck finding replacements locally, so I got on the internet and came across PartSelect.com. I called them on the telephone; and after giving the model numbers of my freezers, the keys were on their way!! I received the keys very quickly and both worked perfectly. I would highly recommend Partselect.com. Charlotte M. Bishop
