This kit has been redesigned. The supply tube is now one piece. This spray arm kit comes with an upper spray arm, holder, water supply tube, and a screw. This kit does NOT include the upper support or mount.
$39.10
In Stock
Order within the next 9 hrs and your part ships today!
This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper and installation screw. This part helps stop your dishwasher from leaking and helps with the ...
$139.24
In Stock
Order within the next 9 hrs and your part ships today!
This 18 ml bottle of white appliance touch-up paint is used to cover scratches or marks on your appliance. The white touch-up paint can be used on refrigerators, microwaves, ranges, clothes dryers, an...
$10.21
In Stock
Order within the next 9 hrs and your part ships today!
This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the desired amount of wat...
$73.11
In Stock
Order within the next 9 hrs and your part ships today!
This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating element.
$28.81
In Stock
Order within the next 9 hrs and your part ships today!
NOTE: This part requires a silicon sealant for installation.
$85.67
In Stock
Order within the next 9 hrs and your part ships today!
Questions And Answers for KUDS24SEBL3
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Pete
November 29, 2021
Serial number: Fh1204080
I purchased this dishwasher in the mid 1990's. It's served us well ... until now. when i select normal/start on the control panel, the rinse & empty light comes on. when i hit cancel, the cycle completes. if i hit normal/start again the same sequence is repeated. is replacement of the control panel likely to solve this problem? i'm willing to invest the cost of a new panel if there's any chance it can be a solution. it's a built in unit so i'd like to repair it if possible.
For model number KUDS24SEBL3
Hello Pete, Thank you for your inquiry. We have researched the model you have provided and we would recommend checking the following parts to fix your issue: the control panel insert/keypad, and the push button switch membrane/control board. Also check the wiring for any visible damage. Good luck with your repair.
Removed spray arm thumb nut. Removed spray arm. replaced worn and broken earings and re-assembled in reverse order. Would have done the repair a lot sooner if I had known that PartsSelect was just a few miles up the highway.
The plastic parts on this spray arm assembly wear with time and the rotation wobble effect creates a wave action in the pool of water at the bottom of the dishwasher. This waves the water onto the front door and forces a leak outside the unit. Replace the lower arm assembly, washer, bearing and nut. They all wear. Also remember to tighten the screws on top of the pump assembly. They loosen and aid in the wobble. Good Luck!