Models > JJW9530BAQ

JJW9530BAQ Jenn-Air Wall Oven - Overview

Sections of the JJW9530BAQ

[Viewing 5 of 5]
Keep searches simple, eg. "belt" or "pump".
Light Bulb - 40W – Part Number: 8009
Light Bulb - 40W
★★★★★
★★★★★
(28)
PartSelect #: PS884734
Manufacturer #: 8009
This an authentic OEM 40-Watt replacement light bulb, used in a number of household appliances. It is specially designed to withstand extreme temperatures, which is why these replacement bulbs are mos...
$14.96
  In Stock
Long Oven Sensor – Part Number: 12001656
Long Oven Sensor
★★★★★
★★★★★
(20)
PartSelect #: PS1570174
Manufacturer #: 12001656
This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.
$47.67
  In Stock
Screw – Part Number: W11233072
Screw
★★★★★
★★★★★
(5)
PartSelect #: PS12349731
Manufacturer #: W11233072
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch...
$26.52
  In Stock
Light Cover Lens – Part Number: WP9781049
Light Cover Lens
★★★★★
★★★★★
(20)
PartSelect #: PS11747414
Manufacturer #: WP9781049
This part goes over top of the light bulb.
$82.18
  In Stock
2 Piece Broiler Pan – Part Number: 4396923
2 Piece Broiler Pan
★★★★★
★★★★★
(2)
PartSelect #: PS971245
Manufacturer #: 4396923
The top of this part is now black.
$47.84
  In Stock
Bake Element – Part Number: WPW10310258
Bake Element
★★★★★
★★★★★
(2)
PartSelect #: PS11752537
Manufacturer #: WPW10310258
This bake element is found on the bottom of the oven.
$162.13
  In Stock
Screw, 8/18 x 3/8 – Part Number: WP90767
Screw, 8/18 x 3/8
PartSelect #: PS11746840
Manufacturer #: WP90767
This screw is sold individually.
$6.91
  In Stock
Oven Rack – Part Number: WPW10282527
Oven Rack
PartSelect #: PS11751911
Manufacturer #: WPW10282527
The oven rack provides a stable surface for cookware inside the oven. Sold individually.
$108.69
  In Stock
Temperature Probe – Part Number: WP71001870
Temperature Probe
★★★★★
★★★★★
(2)
PartSelect #: PS11743863
Manufacturer #: WP71001870
This temperature probe consists of two ends joined together by an insulated wire. The small end is almost four inches long, whereas the longer end is almost seven inches long. The small end, the jack,...
$212.41
  Special Order
Electronic Clock Control Board – Part Number: WP71003424
Electronic Clock Control Board
PartSelect #: PS11743900
Manufacturer #: WP71003424
This electronic clock assembly is seven and a half inches long. It is three inches wide and is intended for use with a range's control panel.
$653.76
  In Stock
Broil Element – Part Number: WPW10310260
Broil Element
★★★★★
★★★★★
(1)
PartSelect #: PS11752538
Manufacturer #: WPW10310260
This broil element is found on the roof of the oven.
$191.54
  Special Order
Screw – Part Number: WP74003976
Screw
PartSelect #: PS11744049
Manufacturer #: WP74003976
This screw is sold individually.
$6.84
  In Stock

Questions And Answers for JJW9530BAQ

Be the first to ask our experts a question about this model!

Common Symptoms of the JJW9530BAQ

[Viewing 9 of 9]
Little to no heat when baking
Fixed by
these parts
Fixing Fixing
Show All
Oven is too hot
Fixed by
these parts
Fixing
Show All
Oven not heating evenly
Fixed by
these parts
Fixing
Show All
Will Not Start
Fixed by
these parts
Fixing
Show All
Element will not heat
Fixed by
these parts
Fixing Fixing Fixing
Show All
Will not program
Fixed by
these parts
Fixing Fixing
Show All
Touchpad does not respond
Fixed by
these parts
Fixing
Show All
Little to no heat when broiling
Fixed by
these parts
Fixing Fixing
Show All
Door won’t open after self cleaning cycle
Fixed by
these parts
Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Oven not holding 350 F, when cooling the coils did not reheat
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. The oven works fine! Note that due to thermal lag the temperature overshoots to 370 degrees and undershoots to 340 degrees, this appears to be normal oven operation. Putting door back in place was easy.
Parts Used:
Long Oven Sensor
  • David from Westford, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
157 of 198 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
F1-1 code
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will cause the plastic plug connector to melt from oven heat.
Parts Used:
Long Oven Sensor
  • charles from marstons mills, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
75 of 100 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
No clock display
1. Turned off the circuit breaker for the oven.
2. Opened oven door used a phillips screwdriver to remove four black screws from under the top panel.
3. Lifted panel slightly & removed from oven.
Removed four screws using 1/4" nut driver to remove old display unit. Disconnected three wire harnesses.
4. Connected three wire harnesses to new display unit & replaced four nut screws.
5. Hang the top panel on the top of oven & replace four screws removed in step 2.
6. Turn on the circuit breaker for the oven.
("Very easy! I'm a 63 yr. old woman!)
Parts Used:
Electronic Clock Control Board
  • Cheryl from Mesa, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
53 of 54 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!