This grease filter is sixteen and a half inches long and nine inches wide. It is made of metal and is intended for use with downdraft ranges and cooktops.
$61.73
In Stock
Order within the next 6 hrs and your part ships today!
This is the replacement surface burner switch for your range. It measures approximately 1.5 inches by 1.5 inches, with a shaft that is approximately 1 inch long. The surface burner switch turns the su...
$107.00
In Stock
Order within the next 6 hrs and your part ships today!
Use this scraper for your ceramic/glass cooktop. It has a retractable blade and is an all-purpose tool for cooktops, mirrors, windows and tile. Use it to also remove paint, paper, dirt, stickers and more.
$13.76
In Stock
Order within the next 6 hrs and your part ships today!
Order within the next 6 hrs and your part ships today!
Questions And Answers for JED8430BDB
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Art
July 2, 2021
Left front element will not heat up the lights work the element has continuity and the switch works. What else is there?
For model number JED8430BDB
Hi Art,
Thank you for your question. If both the burner and the switch have continuity, check the wires connected to the element to see if they have burned out. Also check and make sure the cooktop is receiving the proper voltage. You may use a multimeter to test the light socket. We hope this helps! Good luck with the repair!
Was this helpful?
Thank you for voting!
Angela
July 30, 2021
I want to replace the black rubber piece located underneath the knobs. Can you help me?
For model number JED8430BDB
Hello Angela, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS11757586. The Grommet is sold individually. We hope this helps!
1. Removed potand pans from under stovetop. 2. Disconnected exaust duct. 3. Raised the stove and placed wooden blocks under. 4. Unscrewed old top,and removed. 5. Placed new stovetop on stove, screwed into place. 6. Fresh caulk around opening. 7. Lowered stove into place. 8. Reconnedted duct work.
This was a range top. i removed the 12 hex machine scews holding on the top, then removed the two star screws holding the old switch. there were fore wire that had fitted on tabs. Hooked them to the new swtch and reassembeld. Easy repair since i could lift the unit out without disconnecting main cables. Replacement range would have been oveer $1000. Psrt was under $40 and delivered in a matter of days.
Lift off blower vent cover. Lift out old filter. Clean walls and bottom of down draft using degrease soap and warm water. Dry. Discovered my grease filter will not install diagonally as shown in unit manual. Decided to drop into downdraft and put in front of fan suction. Found this left a gap at the top of fan suction that was not covered by the filter. Cut piece of wood 1 inch thick and width and length to drop down in the downdraft and lay on bottom. Set filter on top of wood in front of the fan suction. Verified that fan suction would pull filter tight against the opening by turning fan on and off. Put vent cover back over downdraft and told wife I was done.
.gif "SUPPLEMENTAL INFORMATIOM Diagram and Parts List for Jenn-Air Cooktop")
