Your washer uses 4 tub dampening straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet and are sold individually.
The main tub seal is located between the transmission and the outer tub. It's the primary water seal in the outer tub for the transmission-shaft. This seal is difficult to replace and should probably ...
This tub bearing goes in your washing machine. You will find it on the bottom of the outer tub, where the transmission goes through the tub. If you hear metal on metal when the washer is spinning, you...
This timer dial with compression ring shows you which part of the cycle your washer is in. It is white in color and can be found mounted on the timer shaft. You may need to replace this part if your ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Patrice
December 9, 2021
French Version Ma laveuse ne spin pas mais elle vidange, quel serait le problème selon vous?
English Version My washer does not spin but it drains, what do you think is the problem?
For model number GTAP1000M1WW
French Version Bonjour Patrice, merci d'avoir écrit. Si votre appareil est surchargé, il ne tournera plus lorsque vous avez des charges moyennes à plus lourdes, je vous suggère de vérifier d'abord votre courroie. Cette partie s'use avec le temps et elle s'est peut-être simplement usée avec la charge plus lourde que vous faisiez. La courroie porte le numéro PartSelect PS270803. Nous avons une vidéo d'installation à laquelle vous pouvez accéder. Nous espérons avoir de vos nouvelles bientôt.
English version Hello Patrice, thank you for writing. If your appliance is over loaded it will no longer spin when you have medium to heavier loads, I would suggest checking your belt first. That part does wear down over time and it might have just worn down with the heavier load you were doing. The belt is PartSelect Number PS270803. We have an installation video for you to access. We hope to hear from you soon.
I spoke to a very nice young ladie who took my order and I received my order within two days. I pull the clasp off of the old knob and replace the knob and the clasp with the new part and it now works great. Thank you for helping me find the part I needed.
1. Drained the wash tub by taking the drain hose from the back of the washing machine and dropping it below the tub - water flowed out of hose a lot easier than trying to suck water out of tub using a pump (tried this on the first time I tried to fix washer). (Washing machine on 2nd floor of house and didn't want water running on floor) 2. Removed the 2 bolts holding the Pump/Motor assembly to the machine. 3. Removed both hose clamps on the Pump/Motor assembly and removed Pump. 4. Attached the new drain inlet hose to the pump and then to the tub with the original hose clamps. 5. Attached the drain hose to the pump and then plugged in the 2 wires for the pump. 6. Plugged in the washing machine and everything worked.
NOTES: 1. Hardest part was working with hose clamps (spring type clamps) in the tight space under the machine. 2. Easier to fix since I pulled machine apart a few days before - removing the clog in the pump/motor assembly only to get everything back together to find out that the motor was dead. Still well worth the time and effort due to not having to go out and buy a new Machine...