This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoid on the valve open and close according to the desired amount of water needed.
The circulation pump adapter, or pump adapter assembly connects the circulation pump to the tub of your dishwasher. If your dishwasher is leaking around this adapter, check the connection to ensure ev...
The hinge link on your dishwasher connects the spring to the dishwasher door hinge. If the hinge link becomes cracked or damaged, you may not be able to shut or lock your dishwasher door properly. In ...
This part is the replacement door hinge cable for your dishwasher. The door hinge cable connects the door spring to the door hinge, and allows the door to open in a controlled fashion. If you open you...
This end cap is sold individually. It is the same end cap used on the right and left side, for both front and back. It attaches to the end of the upper rack slide rail, and prevents the rack from fall...
This is the replacement fine filter hub nut for your dishwasher. It is made of white plastic and is approximately 3 inches in diameter. The fine filter hub nut is also known as the lower spray arm hub...
$77.43
Special Order
Questions And Answers for GDWT360R10SS
Ask our experts a question about this model and we'll get back to you as soon as possible!
3 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bob Handt
February 19, 2020
Smart dispenser is no longer dispensing detergent. Is there a way to clean it out?
For model number GDWT360R10SS
Hello Bob, thank you for your question. You can clean it out by removing it and wiping out the inside but if its not dispensing the dispenser itself probably needs to be replaced. Usually the motor on the back goes bad and the door will not open on its own. I hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Bob
February 20, 2020
I had a question answered about replacing the small detergent dispenser, but the larger smart dispenser is the one that is not working. Does this one also have a motor in the back that can prevent it from working?
For model number GDWT360R10SS
Hello, Thank you for your question. I apologize for the inconvenience but there is no motor for this dispenser.You may just need to replace the dispenser. Good luck with this repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Bob
February 25, 2020
Diagram #872 how do you remove the dishwasher lock nut from the fill tank?
For model number GDWT360R10SS
Hello, Thank you for your question. You will need to remove the parts around it first and the nut should just pull out. We hope this helps.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
All I had to do is take out the rack, pop off the old wheels, place the new stud rollers on, then pop on the new wheels. So easy and now my dishes don't get chipped when I pull the rack out and push it back in. I wish I didn't wait so long to order new parts.
Pull old rack out, slip new one in! One thing i did was order wheels and studs as i was unaware they lower rack came fully equiped with all wheels,studs, and flip up dish dividers. So if your replacing the rack no need to order the wheels! The diagram made it look as if you only et the wire rack and not all the added pieces.