The relay switch may also be known as the door micro switch and is a part for your microwave. The function of this part is to monitor the door latch and communicate whether the door latch is open or c...
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Emily
July 27, 2023
Need to know about mounting bracket for Canetti instalation
For model number FGMV185KFA
Hi Emily, thank you for asking. The mounting bracket for your model is part number, PS2343044. This mounting bracket is used to mount microwaves to the wall when installing the unit over a range. This mounting bracket is approximately 31 inches long x 2 inches wide. We hope this information helps!
Microwave operates ok except have a few of the segments of the led display not working and the more annoying part is the end of the cycle beeper is very faint Is the beeper a replaceable part
For model number FGMV185KFA
Hello Rick, thank you for reaching out. Based on the description that you have provided, the issue is most probably with the control board, part number PS3493236. You may need to replace it to fix the issue. Glad to be of assistance!
I first removed the top plate above the microwave door (3 screws), then I removed the plate containing the buttons and clock. The microwave has 3 relay switches and they are in a little holder. The holder was too difficult to remove so I just removed the bottom switch and replaced. The microwave started right up.
was told buy a repair person to check the door micro switches as it was a common problem. removed the top plastic air grill to get access to the screw that holds in place the control cover. After unplugging the unit, i took out the (2) screws that held in the switches and removed them (3). One switch was a bit melted so i tested it with a 12 volt battery and it was bad. Ordered a new one from Part select and got it fast . Works great .
After unplugging the unit remove the control face buy removing the screws. All three door switchs are on a bracket on the left. Remove the two screws holding the bracket in place and pull out. Disconnect the wires from the three switches and test each switch indivually to determine the bad one. I used a multimeter set on ohms.Replace the bad switch with the new one and replace all the wires. Reassemble the unit and you are good to go.