Also known as Probe. The quick connect on this part may be different than your original part. If it doesn't fit, you have to cut off the quick connect and wire together with porcelain wire nuts.
$64.15
In Stock
Order within the next 8 hrs and your part ships today!
Order within the next 8 hrs and your part ships today!
Questions And Answers for CPCS3085LFA
Ask our experts a question about this model and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Norma
February 16, 2020
A error flashes # 32 what do this mean ? It happened after a power outage. Is there a way to reset my stove
For model number CPCS3085LFA
Hello and thank you for writing.
We suggest to try a hard reset:
Go to your breaker box and shut the breakers for your unit off, wait 5 minutes and then turn the breaker to on again. That should hopefully clear this problem.
This is from your tech datasheet.
ERROR 32=12V on the service section to low (relay board).
1) Verify harness between Induction Generator Housing & Relay Board.
2) Change the Relay Board. PS1992555
3) Replace the Induction Generator Housing.
We hope this helps. Please contact us anytime if you require further assistance.
All my cook top not operating. My oven run good but I have a alarm. Error code would 95.
Série: 316560143
Can you find my problem?
Do you have a part for fix this problem?
For model number CPCS3085LFA
Hello Ghislain, thank you for your inquiry. This error code indicates that the top elements are not getting any power. We recommend you replace the fuse, part number PS1529647, on the induction power control board. If the fuse is good, then the issue seems to be with the board. We would suggest checking it, the part number is PS1151676, to fix the issue. The induction power control board sends power to the induction coils. We hope this sorts out your problem!
Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with two screws; the back of the oven will need to be removed to unplug. Reverse removal procedure and turn the power back on to the stove.
PF alarm appeared on display. Noticed clicking when cord was moved. Had arced for some time and melted original block. New part slightly different. Only has 3 lugs, old one had six. Stack using washers provided. Take note of colors before disassembly. Use caution while working through access opening. The edges are sharp. Only tools needed are phillips screwdriver, deep socket for lug nuts. Nut driver optional. Hope this is helpful.
Repair was quite easy, as long as you have the instructions for removing the door. The screws that hold the bottom of the door to the fixed hinge are placed into the side of the hinge assembly after removal; this holds the door at a 45 degree angle for easy removal. After that, just place the door on a flat surface and dismantle the door from the inside. The inner glass is contained in a metal frame with another piece of glass; this frame comes apart easily using the clips in each side. The door assembles easily after the glass is replaced; just take your time and give yourself enough room to lay out the parts as you go. Good luck!