This is a replacement burner cap for your gas range or cooktop. The burner cap is found on the burner head, and prevents debris from getting into the head when it is not in use. The cap is black in co...
This burner cap is for your gas range, and acts as a cover for the burner head. It is black in color and just over 3 inches in diameter. If your old burner cap is damaged or missing, this is the part ...
This is a burner cap for your gas range. The cap acts as a cover for the burner head. If your old burner cap is damaged or missing, this is the part that will replace it. The cap is black in color and...
This economic nut is a manufacturer-approved replacement part for your oven range. The nut can become worn down or stripped over time and need replacing. Make sure to disconnect power to the unit and ...
New burner cap replaced old; just placed over burner; no tools required.
One suggestion: burner cap should have been shipped with thicker bubble protection (easy to do). It was minimally wrapped and placed in a thin, bubble envelope, risking damage in shipping process. Luckily, the burner arrived in tact and usable.
The following are steps in replacing a burner electrode for GE Profile Cook Top Model PGP7030DL1BB 1. Shut off gas and unplug electrical plug 2. Remove all stove grates and turn on knobs 3. Remove all burner covers 4. Remove all screws [three for each burner] 5. Remove two screws near front by removing rubber grate grommets 6. Carefully Lift off stove cover and set aside 7. Remove shield near back of stove top. This exposes all burner wires 8. Remove electrode to burner which does not lite by sliding out clip at bottom of electrode—note color code of wire and replace with same. Change one electrode at a time to insure wire color code is correct. 9. Reassemble in reverse order of steps 1-8
