Models > 79572373312

79572373312 Kenmore Refrigerator - Overview

Sections of the 79572373312

[Viewing 7 of 7]
Keep searches simple, eg. "belt" or "pump".
Plastic Tube - 5/16 Inch – Part Number: MJU62070602
Plastic Tube - 5/16 Inch
★★★★★
★★★★★
(4)
PartSelect #: PS3536013
Manufacturer #: MJU62070602
$29.11
  In Stock
ELBOW – Part Number: MDB61861102
ELBOW
PartSelect #: PS12716068
Manufacturer #: MDB61861102
$15.91
  In Stock
Tube Assembly,Ice Water – Part Number: AJR56656503
Tube Assembly,Ice Water
PartSelect #: PS3533046
Manufacturer #: AJR56656503
$36.17
  In Stock
WATER INLET VALVE – Part Number: AJU72992603
WATER INLET VALVE
PartSelect #: PS3618979
Manufacturer #: AJU72992603
$142.02
  In Stock
Spring,Lever – Part Number: 4970JA3011K
Spring,Lever
PartSelect #: PS3524589
Manufacturer #: 4970JA3011K
$19.44
  In Stock
GASKET,DOOR – Part Number: MDS38201426
GASKET,DOOR
PartSelect #: PS11758511
Manufacturer #: MDS38201426
Freezer door gasket is on the inner door panel and creates a seal around the door to prevent warm air from entering the freezer compartment.
$87.14
  On Order
Switch,Micro – Part Number: 6600JB3001C
Switch,Micro
PartSelect #: PS3529276
Manufacturer #: 6600JB3001C
$42.75
  In Stock
Ice Maker Assembly - 3 Wire – Part Number: AEQ73110203
Ice Maker Assembly - 3 Wire
PartSelect #: PS7788172
Manufacturer #: AEQ73110203
NOTE: The Secondary (smaller) wire connector has 3 wires in it. If original ice maker has 6 wire connector see part number AEQ73110205. Please verify connector before ordering.
$372.15
  In Stock
SENSOR,TEMPERATURE – Part Number: EBD60925804
SENSOR,TEMPERATURE
PartSelect #: PS7792212
Manufacturer #: EBD60925804
$34.57
  In Stock
Clip – Part Number: 4004JA3002A
Clip
PartSelect #: PS3522801
Manufacturer #: 4004JA3002A
$21.16
  Special Order
BASKET,DOOR – Part Number: MAN62429901
BASKET,DOOR
PartSelect #: PS7794175
Manufacturer #: MAN62429901
$60.23
  In Stock
Front Door Mullion – Part Number: AGU75407901
Front Door Mullion
PartSelect #: PS11709013
Manufacturer #: AGU75407901
$222.71
  In Stock

Questions And Answers for 79572373312

Be the first to ask our experts a question about this model!

Common Symptoms of the 79572373312

[Viewing 6 of 6]
Leaking
Fixed by
these parts
Fixing Fixing Fixing
Show All
Door Sweating
Fixed by
these parts
Fixing Fixing
Show All
Door won’t open or close
Fixed by
these parts
Fixing
Show All
Ice maker won’t dispense ice
Fixed by
these parts
Fixing
Show All
Frost buildup
Fixed by
these parts
Fixing
Show All
Not dispensing water
Fixed by
these parts
Fixing
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water feed line running from water valve to filter housing was leaking
Shut off water supply. Disconnect main supply line. Remove rear lower panel on back of refrigerator. Remove all tubing clamps on back. Disconnect leaking tubing from water supply valve. Remove water filter and unscrew/remove water filter housing. Replace tubing - connect to water filter housing then to water supply valve. Reconnect filter housing and filter. Reinstall lower panel, then main water supply line, then all tubing clamps. Turn water back on and check for leaks after discarding several glasses of water to fill filter. Job complete!
Parts Used:
Plastic Tube - 5/16 Inch
  • Tom from EASTON, PA
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Wrench (Adjustable)
11 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Changing out the Ice Maker tube
An easy way to get a refrigerator out from the wall is to use a tow strap or 1/2 to 3/4 in. rope. Throw a loop behind refer while keeping both ends in your hands. Let it settle down to the lower half of unit and pull using both hands. Comes right out.
Remove lower panel. Unscrew water valve from cabinet. Remove all tube holders Lay some rags down to catch a little water drainage.
Turn off water supply valve at wall. Unplug Power. Remove filter and filter holder. (one screw).
remove tube from valve by removing plastic C clip. Push plastic ring towards the valve and pull out tube at same time.
With the tube free, remove filter, then mount screw to remove the inside filter holder. When it is out, pull the tube doing the same process as the lower end. Pull tube out and replace with new one putting everything back in reverse order.
Before placing tube holders back on, turn on water to check for leaks.
After turning water back on and plugging in power, push refer back into place.
While I was there, I also replaced the hose from the wall to the refer.
Parts Used:
Plastic Tube - 5/16 Inch
  • HARRY from SPARKS, NV
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers, Wrench (Adjustable)
8 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice chute would not open.
Removed ice dispenser and display with small screwdriver from front of the fridge. Pried out the whole piece slowly. This exposed the motor that activates the chute. Plugged in the new motor before any removal to verify the motor was the problem. When it worked, removed old and installed new. 3 screws. Piece of cake.
Parts Used:
MOTOR,DC
  • Steve from MUKWONAGO, WI
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
13 of 29 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!