Amana Range Switches

Surface Burner Element Switch, Large Burner

★★★★★

★★★★★

22 Reviews

This control switch controls the stove top 8" surface burner. 8.9- 11.0 amp. This surface burner element switch is for an 8-inch surface burner on an oven, stove, or range. The element switch controls the heat of the surface burner. Disconnect power to your range before completing this repair because you will be working closely with electrical circuits. Remove the screws from back panel and the console, and remove the console to expose the switch. It is recommended to check for overheating or arcing on the wiring harness in case they need to be replaced as well. The harness that connects to the switch features a slip-on terminal for easy installation.

Dual Element Control Switch

★★★★★

★★★★★

12 Reviews

This switch controls the stove top surface burner.

Infinite Control Switch, 6"

★★★★★

★★★★★

5 Reviews

This switch controls the stove top 6" surface burner.

Range Infinite Burner Switch - 8 Inch

★★★★★

★★★★★

14 Reviews

This infinite switch for eight inch range burners is almost three inches long. This infinite switch is for 8-inch range burners. When an element is unable to produce any heat on a modern oven, the problem may lie with the infinite switch. This switch is responsible for sending power to the surface elements. Check the element and terminal block to ensure they are working properly. If they are in working order, check the infinite switch at the control panel for any wires that have overheated, or broken terminals to or from the infinite switch. If the infinite switch is damaged or malfunctioning, it will need to be replaced. Remember to unplug your range before beginning this repair.

Infinite Switch - 6 Inch

★★★★★

★★★★★

1 Review

This part carries 5.2-6.6 amps.

Dual Surface Burner Switch Kit

★★★★★

★★★★★

5 Reviews

This switch is used to operate the dual surface burner.

Infinite Switch - 8 Inch

★★★★★

★★★★★

9 Reviews

Sold individually.

Surface Element Switch

★★★★★

★★★★★

1 Review

Dual Surface Burner Switch

★★★★★

★★★★★

2 Reviews

This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch: 1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2). 2) Do not connect the pilot lamp (P) wire yet. 3) Reconnect the power to the range and turn on the new switch and one other switch. 4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on. 5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed. 6) Disconnect power, reverse Line Wires if needed and connect the P wire. 7) Reconnect power to the range after reassembly.

Infinite Dual Switch

★★★★★

★★★★★

2 Reviews