Refrigerator Circuit Boards and Touch Pads

This defrost timer will cycle for thirty minutes after every eight hours of run time.

This board will need to be programmed upon installation. The electronic control board is used in refrigerators to monitor and manage the temperature settings, such as cooling or defrosting times. If your fridge or freezer is too warm, too cold, is not defrosting, will not start, and/or runs too long then replacing the control board could solve your appliance problem. The tools needed for this installation project is a small flat blade screwdriver. *Please note: the board will need to be programmed after installation. Remember to unplug refrigerator from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions and accurate guidance.

This eight-hour defrost timer will replace most other defrost timers. This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater. The best way to make sure you get the correct timer for your refrigerator is to conduct a search for your model number. NOTE: The black lead on the defrost timer, will go to terminal number 2.

This is a 6hr 21 min defrost timer.

This defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are internal, and the label is orange.

This is the replacement façade insert for your refrigerator. It is essentially the control panel that allows you to choose between water and ice, select different types of ice, turn on the light, and lock the control panel. If your refrigerator will not dispense ice, or if you are not able to select from the above options, you may need to replace the insert. This insert is black in color and is oval shaped. Be sure to check that this insert matches the damaged insert on your refrigerator. This part is sold individually.

This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

These boards tells the icemaker when it's full and that it has to dump the ice, and it also tells the icemaker when to refill with water.

The timer will shut off the cooling system of the refrigerator and the defrost heater will turn on.