See part 27 in the diagram
( Grid squares measure 1x1 inch )
Dryer Drum Seal with Adhesive
$54.14
On Order
On Order
Get this part fast. Average delivery time via standard shipping: 1.8 days.
PartSelect Number PS970088
Manufacturer Part Number 280114
Manufactured by
Whirlpool
Product Description
Dryer Drum Seal with Adhesive Specifications
This part seals the drum to prevents air from escaping. This includes silicone rubber adhesive.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part fixes the following symptoms:
Noisy | Marks left on clothes | No heat or not enough heat | Takes too long to dry
This part works with the following products:
Dryer, Washer Dryer Combo.
This part works with the following products:
Whirlpool, Kenmore, Maytag, KitchenAid.
Part# 280114 replaces these:
AP3790434, 1065278, 280114, 280114VP, 3403265, 697694, W10116343, W10166807, W10521118
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Chris
January 2, 2018
Does this kit do both the front and rear felt seals on the drum, or do you need two kits?
For model number 11076934690
Hi Chris, Thank you for the great question. This kit is just one seal with one tube of adhesive, if you are replacing both front and rear seals you will need to order two kits. Good luck with the repair!
18 people found this helpful.
Was this helpful?
Thank you for voting!
David
December 17, 2019
Does this drum seal also fit the front of the dryer?
For model number WGD9150WW0
Hi David,
Thank you for your question. Yes, this seal is used for both the front and the rear of your dryer. We hope this helps. Thank you and have a great day!
7 people found this helpful.
Was this helpful?
Thank you for voting!
Patricia
January 23, 2020
My dryer seal on the door is not glued down in one small section. Can I use the adhesive glue to glue down loose section or do I have to replace entire seal? Old, used, dryer. Not worth putting a lot of money into.
For model number GEQ9800PW2
Hello Patricia, Thank you for the question. You can use a High Temperature silicone rubber adhesive used in dryers to reattach that section of the seal. We hope this helps.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Dan
November 10, 2019
I found this seal that came loose inside the drum. Does that mean i need to replace the seal on inside of the back of the drum in that groove and not the outside of the drum?
For model number LEQ8611LG0
Hello Dan, thank you for your question. The felt seal at the back of the drum wraps around the lip. So the one seal seals the inside and outside of the drum. I hope this helps.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Chari
February 19, 2018
Will this help with snagging my clothes. If not - please tell me which part is.
For model number WGD8300SW0
Hello Chari, thank you for your question. The parts you would want to replace to fix this issue would be the Dryer Drum Seal with Adhesive 280114. There are two of these on the unit, one that goes around the front of the drum, and the other goes around the back lip of the drum. I hope this helps!
Was this helpful?
Thank you for voting!
Customer Repair Stories
Average Repair Rating: 2.8 / 5.0, 3 reviews.
What's this?
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Rear tub seal failure
I removed the top cover and then the back cover, released the belt tensioner and removed the drive belt. Then slid the tub out of the unit and onto the back dack. Sanded the remnents of the old seal off. Wiped the tub lip with laquer thinner and applied the "fast" drying glue supplied with the kit. Installed the seal and re-assembled the unit...works fine
-
Jerry from Everett, WA -
Difficulty Level:Easy -
Total Repair Time:30 - 60 mins -
Tools:Screw drivers, Socket set -
Parts Used:280114
62 of 79 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rear dryer drum seal came out
Used my Whirlpool Dryer User Instructions Manual and followed instructions and used the Cabinet Parts page to see the diagrams.
-
William from Pontiac, MO
-
Difficulty Level:Easy
-
Total Repair Time:More than 2 hours
-
Tools:Screw drivers, Socket set
-
Parts Used:280114
16 of 28 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Rear seal was damaged and started falling apart.
Had loud squealing prior knew rollers was going. Ordered repair kit that contained new belt , idle pully, and rollers. Knowing I had previously mended the door switch ordered a new to replace it. Unplugged and removed the dryer. Removed front lower panel, then the top and took the screws that held the front panel and door switch. Then I took the belt off and removed the drum. Removed the rear felt and cleaned the drum with fine mesh steel wool applied adehesive waited 5 mins and attached new felt. Then went to work cleaning the inside of the dryer with an air compressor. Rollers were next, poped the retainers and slide old ones off whiped the studs with a rag and put new ones on. Did the same with the belt tensioner pulley that came with the kit. Installed the new door switch and reassembled the dryer. Works great again, quiet etc. Easy fix and glad I ordered the kit.
3 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer Reviews
Filter By Rating:
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
Ken P - June 29, 2020
Perfect fit replacement part.
Came with clear instructions and was simple to install.
Dwight L - June 12, 2020
Easy Repair and arrived fast
The part arrived fast and the dryer is working again. Thank you for the great service.
Ken G - February 19, 2020
As advertised..good fit..
Parts were just what I needed..prompt delivery
Norman4724 F - November 6, 2019
Worked as expected
The part that I got from you guys was awesome !! Fit on the drum no problem nice tight fit put everything back together work like a charm.
Flora V - April 30, 2019
Dryer felt strip.
Repair went smoothly and the part was a perfect fit. It shipped really fast too.
Steve B - April 22, 2019
Easy repair and worked as expected.
The video was extremely helpful and was the reason I purchased my item from this company. The part was in great condition and everything back to normal for now. Found the shipping expensive but received the item very fast...in 2 days. Now I need a new roller wheel but I am putting it off because the shipping ($10) will be more than half the cost of the item ($15). :(
Robin F - February 28, 2019
Part looked, worked like the OEM.
The part was easy to replace and the adhesive created a great bond between drum and seal. I put the seal on the drum first and then applied the adhesive between the part and drum. It tacked up quickly and seemed easier to apply that way versus the installation instructions.
Jerry R - January 8, 2019
Wrong part
The part was fine but unfortunately wasn't the part I needed, my fault, not theirs.
Clint R - September 22, 2018
Good part- working well
The part came overnight and my dryer is working much better. Previously it was leaving brown marks on light and coloured clothes and extended drying times. I changed the seal on both ends of the drum. Is was fairly expensive for 2 parts and an extensive repair requiring complete disassembly of the cabinet. I would recommend changing the belt while it’s already disassembled
Related Parts
$59.90
Silicone Rubber Adhesive - 2 oz
$59.90
PartSelect Number: PS11740605
This is a high temperature adhesive that is used for gaskets and felt seals.
Model Cross Reference
This part works with the following models:
PartSelect Number: PS970088
Manufacturer Part Number: 280114
Manufacturer Part Number: 280114
Brand
Model Number
Description