Troubleshooting
This part fixes the following symptoms:
Door won’t open or close | Door Sweating | Fridge too warm
This part works with the following products:
Refrigerator.
This part works with the following products:
Frigidaire, Kenmore, Crosley, Westinghouse.
Part# 242193206 replaces these:
AP5806733
Customer Reviews
Filter By Rating:
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
LEONARD S - September 20, 2024
Verified Purchase
fabulous
Received part in perfect condition and installed it in minutes. Perfect fit!
Gary B - August 25, 2022
Verified Purchase
Fast repair
Delivered quickly and well boxed to protect it from damage. Wish it was a little lower priced...but what can you do?
- < Prev
- 1
- Next >
Customer Repair Stories
Average Repair Rating: 4.9 / 5.0, 6 reviews.
What's this?
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Refrigerator section wasn't chilling
I pulled the old gasket off and thoroughly cleaned the entire refrigerator door, including the area where the gasket would pop into. Starting at the two upper corners, I pushed the corners into the ridge in the door and used my thumbs to press the gasket in along the top of the door. I then went about halfway down the door using my thumbs to push in the gasket. Then I pushed the lower corners in, taking my thumbs up either side of the door to finish installing that section then I pushed the bottom in, checking the lower corners to make sure they were secure. Then I closed the door and made sure the seal was secure on both sides of the door.
Other Parts Used:
-
Lorrie from LOMPOC, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
15 of 16 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Worn out gasket so air escaping
Pull off the gasket and replace by pushing into the grooves.
Other Parts Used:
-
Daniel from WASHINGTON, DC
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
9 of 10 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Torn gasket
Replacing the gasket is easy, just remove the old gasket by pulling it out of its grove and push in the new gasket in place.
Other Parts Used:
-
Bobby from GILBERT, SC
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
7 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door seal on refrigerator was bad had to change took longer to remove new seal from packaging than removing old seal and reinstalling new seal it was a perfect fit and perfectly packaged ready to Install
Opened refrigerator door removed old door seal by pulling door seal loose from door with fingers installed new seal by pressing new seal back in by hand took roughly 10 minutes to do only issue I had was with delivery my package was sent to the wrong house and was received 3 days late
Other Parts Used:
-
John from DECATUR, AR
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
6 of 6 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The original door gasket was in very bad condition due to neglect.
Easily removed the original door gasket starting at an upper corner by pulling the old gasket off completely. I then cleaned the area where the new gasket was to be pressed into the channel on the door of the fridge. I also cleaned the area on the fridge where the new gasket would seat upon completion of the installation.
With that completed, I began in the upper right corner of the door, easily pressing the new gasket into the channel on the fridge door. I then pressed the upper left hand corner of the gasket into place, into the channel on the door. I then pressed the entire upper horizontal part of the gasket into the channel along the top of the fridge door.
I then pressed the left and right vertical portions of the gasket into the channels on the fridge door. I then pressed the lower left corner of the gasket into place, followed by the lower right hand corner into place of the bottom channel of the door.
Lastly, I pressed the lower horizontal portion of the gasket completely into the channel of the bottom of the fridge door.
Finally, I rechecked all portions of the gasket to be sure they were securely fitted into the channel of the door.
Mission accomplished in less than 15 minutes. It's a piece of cake to make this repair!
With that completed, I began in the upper right corner of the door, easily pressing the new gasket into the channel on the fridge door. I then pressed the upper left hand corner of the gasket into place, into the channel on the door. I then pressed the entire upper horizontal part of the gasket into the channel along the top of the fridge door.
I then pressed the left and right vertical portions of the gasket into the channels on the fridge door. I then pressed the lower left corner of the gasket into place, followed by the lower right hand corner into place of the bottom channel of the door.
Lastly, I pressed the lower horizontal portion of the gasket completely into the channel of the bottom of the fridge door.
Finally, I rechecked all portions of the gasket to be sure they were securely fitted into the channel of the door.
Mission accomplished in less than 15 minutes. It's a piece of cake to make this repair!
Other Parts Used:
-
GARY from SEMINOLE, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
5 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door Gasket was torn. The frig door not sealing properly
I peeled off the torn door gasket. Then installed new door gasket pushing and pinching it into place
Other Parts Used:
-
Matthew from FORT WAYNE, IN
-
Difficulty Level:Very Easy
-
Total Repair Time:Less than 15 mins
5 of 7 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
- < Prev
- 1
- Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
- < Prev
- 1
- Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Ana
August 6, 2018
I need refrigerator door seal and need the correct one. I read a review and they said they were sent the wrong seal twice. Don't want that to happen. The model # fftr1821qw3 & serial # ba60729677. Thank you so much, Ana
For model number FFTR1821QW3 and Serial: BA60729677
Hi Ana, Thank you for your question. This would be the correct gasket for your appliance. I hope that helps. Good luck with your repair.
5 people found this helpful.
Was this helpful?
Thank you for voting!
Stacy
March 16, 2023
Was having water dripping from the back corner / edge of the fridge. Water accumulates on the bottom. Noticed a tear in the lower corner of the gasket and it looked slightly collapsed. Ordered new door gasket and installed but now door closes worse / will not stay closed. I have made sure gasket is installed all the way around and secure. door seems to have more clearance at the bottom then top along leading edge. Am I missing an adjustment? Hinge points appear to be fixed? Do possibly hinge points need replaced also? Thank you for any information you can provide. I do not believe the door itself is bent.
For model number FRT21P5AW7
Hello Stacy, thank you for the question. The door gasket you mentioned is not compatible with your model. This can cause the door gasket to not be seated properly. However, the compatible door gasket for your model is part number PS2331952. We have also attached a video for proper installation. If the issue is not solved after the proper replacement of the gasket you need to check the defrost drain tube, part number PS430889. We hope this solves your problem!
4 people found this helpful.
Was this helpful?
Thank you for voting!
Related Parts:
Julie
January 13, 2022
Will this refrigerator door gasket fit my model?
For model number 10660232903
Hello Julie, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS323895. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Related Parts:
Donald
May 27, 2022
Does this fit this Kenmore model
For model number 253.60412415
Hello Donald, thank you for your question. Yes, the Gasket PS9493819 you had chosen is compatible with your model. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.
2 people found this helpful.
Was this helpful?
Thank you for voting!
Liudmila
October 15, 2019
I need refrigerator door and fseal and need the correct one.
For model number 596.69142991
Hello Liudmila, thank you for writing. The replacement Refrigerator Door Gasket for your model is part number PS11738526, but unfortunately the Door itself is discontinued. We have no replacement information for it. You will need to reach out to Amana directly for a substitution part number. Please feel free to get back in touch with us if they provide you with one. Thank you!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Deon
May 15, 2023
What are the gasket dimensions?
For model number FFTR1814QW9B
Hello Deon, thank you for your question. The gasket measures approximately 29” x 42.5” inches. We hope this helps.
Was this helpful?
Thank you for voting!
Diane
August 15, 2023
How do I install the gasket ?
For model number fftr1821two
Hi Diane, thank you for your question. We have found some relevant instructions for you to replace the door gasket. You may follow the following steps: you may need to pull off the old gasket. To install the new gasket, start from the corner, insert gasket into the channel on the liner. After installation, use a hair dryer to remove kinks, if any. Good luck with your repair!
Was this helpful?
Thank you for voting!
Michelle
August 15, 2023
Fridge is sweating inside and was trying to order the correct gasket. Can you tell me which one for the above mentioned model?
Thank you
For model number FFHT1826LWB
Hi Michelle, thank you for your inquiry. The door gasket for the fridge is part number PS9493819. If you need help placing an order, customer service is open 7 days a week!
Was this helpful?
Thank you for voting!
Eve
June 21, 2024
does this fit my frig model and does it come with freezer & frig gasket?
For model number 36370247000
Hello Eve, thank you for contacting us. I have researched the model number you have provided and have found the parts you are looking for are part numbers PS296968 and PS296969. These parts are sold individually. If you would like assistance placing an order, please contact customer service. Good luck with your repair!
Was this helpful?
Thank you for voting!
Related Parts:
- < Prev
- 1
- Next >
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS9493819
Manufacturer Part Number: 242193206
Manufacturer Part Number: 242193206
Brand
Model Number
Description