Control Knob and Clip - White

Pulled off old knob and aligned new knob and pushed on. Videos sent with order was very clear and great customer service tool.

The repair was so easy when I got the part, I did it myself without any help in 5 seconds!

Removed clip from old knob with needle nose pliers and removed knob. Pulled indicator dial off of the timer shaft. Removed three screws with nut driver from top of back panel and opened control panel.
One screw holds the timer mechanism in place. Unplugged wiring harness from timer and removed screw. Removed timer. There are tabs that the timer sits in. Make sure you have reinstalled the timer correctly in place.
Installed new timer and replaced screw. Closed control panel and replaced the three screws in back panel.
Slid indicator guide down over timer shaft making sure to line up the tab on dial with notch in nylon shaft. Slide know over metal shaft and replace the clip which holds the knob in place. Operate washer according to instructions. In the future be sure to turn your knob slowly when setting the wash cycle. Turning it too quickly can wear out or break the parts once more.

Replaced timer switch, stem was stripped. Also found all 4 knobs cracked, which surprised me. . Unit only 2 years old, replaced them also. All repair done from top, removed top then control panel, popped knobs off, replced them. Working good now.

Use snub nose plier took less than fifteen minutes.

removed the facia and removed the switch

I removed the three screws that hold the front switch cover to the backing plate. I then slid the front cover to the right and pulled it out and forward. I marked all the wires and removed them. Now the front cover is free. starting from the left i removed the knobs and the switches. The switches have a tab on them and they twist out of their socket. The front cover plate was also broken so I replaced it. In the new front cover plate I installed the switches starting from the right. When I got to the start switch I installed a new switch and knob.I then installed the rest of the knobs. then I installed the wires and put the tabs in their place and slid the cover plate to the left and installed the three screws.I then tested it and it worked great .

Just slipped it on. No problems, No Tools.

Shut off the Electric at the breaker panel. With a Philips head screw driver took off the metal plate, and slide the backsplash out of its holders. Twisted the three switches, twisting to the left to remove them and replace the back splash, controller, timer switch and installed the new rotary switch with a right twist. There are three wires on the rotary switch, just follow the line of the old switch. Replaced the back metal panel, and turn on the breaker. Replacement takes about 30 minutes along with putting the dryer back in place.

I checked the motor,it was bad I was pulling to 20 amps too much. The washer was still not working and the motor was bad so I checked the lid switch for continuity. The switch was a magnet type so with the lid down you should have continuity. In other words, a closed circuit. When the lid is opened, you should have a open circuit, Which would show no continuity. An open circuit means a break in the circuit. To change hinge bushings, raise lid, remove the screws on the outside of the lid, remove hinge, remove lid, insert new hinge bushings, place hinge through lid into bushings, and then put the screws back into the lid. If you followed these steps you should be done.