Water Dispenser Fitting and Tube Assembly

Hi Betty, This appliance unfortunately does not have an anti-drip valve. You could replace the tubing but I would suggest inspecting the parts to try and pin point where the dripping is coming from. It could even be your water inlet valve that is causing the dripping. I hope that helps!

Hello Paul, Thank you for your question! Upon reviewing your model I show that PS886371 is the correct part now being suggested for this model. Good luck with your repair!

Hi Carol, Thank you for your question. You can remove your front cover with a putty knife. Cover the edge of your putty knife with a piece of painters or masking tape. There are two indents at the bottom part of your frame. Slip the putty knife between your frame and your fridge at the bottom right and left hand corners. Then pull toward you and up. That should pop off your frame from being locked into place and you will be able to remove it. When disconnecting the switch from your fridge to remove the front cover entirely, be sure to unclip your wiring harness at the back. Good luck with your repair.

Hi Tony, Thank you for the question. I suggest testing the Micro Switch, PartSelect Number: PS11738948 with a multi meter to check for continuity or if it is stuck. Hope this helps!

Hello Lillie, Thank you for contacting us. I suggest checking the following parts: PS11739027 Control Bracket, PS11738948 Micro Switch, PS3497634 Water Inlet Valve, and PS11722128 Single Water Filter. Good luck with your repair!

Hello Robert, Thank you for your inquiry. We do not show a shut off valve on the water dispenser. I would advise checking the water supply tubes for any cracks or clogs, and check the water filter and water inlet valve. Hope this helps!

Hello Don, Thank you for your inquiry. It can crack or get clogged. Check the lines to make sure they are not frozen, then disconnect them and run water through them to see if there is any leaks. You may also have an issue with the connecters/fittings as well. Hope this helps!

Hi Tom, Thank you for your question. It sounds like you will have to replace your water inlet valve. I could suggest testing it with a multi meter to double check if it is working correctly. I hope that helps. Good luck with your repair.

Hello William, thank you for your question. The only part that is guaranteed to fit and recommended for your specific appliance is PartSelect Number: PS11742481. This is the one that is compatible with your unit. The overall installation should be the same as the video for PS886371. I hope this helps!

Hello Terry, thank you for your question. We would recommend testing the Micro Switch Part Number: WP2162361 to determine if it has failed. If the switch doesn't activate the unit will not dispense the water. If that part is fine, the issue could be with the dispenser port on the valve which would require the water valve be replaced. I hope this helps.