This knob accepts a D shaped shaft. Sold individually. This control knob is for dryers.
Control knob lets you control cycle settings.
Remove the knob by pulling it straight off its post.
How Buying OEM Parts Can Save You Time and Money
Troubleshooting
This part fixes the following symptoms:
Timer Not Working
This part works with the following products:
Dryer, Washer.
This part works with the following products:
General Electric.
Part# WE01X20380 replaces these:
AP5805162, WE1M1028, WE1M1034
Customer Repair Stories
Average Repair Rating: 4.9 / 5.0, 12 reviews.
What's this?
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Dryer control knob fell off and I noticed it was cracked.
Ordered another control knob and put it on dryer and it works great! just really stuck it back on the spindle and "WaLa" it was back to its old self again! Simple as 1,2!
Other Parts Used:
Betty from FERRIDAY, LA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
13 of 14 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The dryer knob cracked
Received the dryer knob, aligned the part and it went on with no tools, no labor.
Other Parts Used:
Patricia from HENDERSON, NV
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins
4 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Control knob broke.
1. Firmly grasp broken knob and pull it off. 2. Line up knob with post and push new knob on to post. 3. Quietly drink a beer and watch NFL mobile on your phone In the laundry room for a minimum of thirty minutes. ( For best results and to keep you from walking into the kitchen, stash a beer in the laundry room before you begin.) 4. Before leaving laundry room, do fifteen jumping jacks and twenty push ups-- enough to get your face red. Sprinkle some dryer lent in your hair. Crush can and throw it behind the dryer, no one ever looks there. 5. Immediately find your wife upon leaving the laundry room, and explain to her that the dryer is now fixed, you are exhausted, and need to take a nap.
Other Parts Used:
Eric from MINONK, IL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
3 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Timer became difficult to turn causing control knob to strip out.
Generally followed directions by another customer that was provided with order. Much appreciated for this DIY. Do have extra comment so here goes. 1. Unplug dryer from wall and remove existing control knob. 2. Remove three screws on back of control compartment and fold the front forward. 3. Remove tiny anchor screw for timer and twist loose. 4. Transfer wire from old to new one at a time. (Extra comment - I thought at first there was problem with new timer because there were more wires than connectors. Some of the wires had double connectors. That hiccup in installation was caused by my inexperience with this first time effort.) 5. Reconnect timer to dryer compartment with tiny screw. 6. Replace three screws on back. 7. Add new control knob, plug up dryer, and it is done.
Dryer knob was stripped. Unable to turn to select time to dry.
Pulled old knob off. Aligned new knob. Pushed on. Took less than 1 minute, no tools required. Expensive for a knob. But it fixed the problem better than switching another knob from the machine.
Other Parts Used:
Gayle from STURBRIDGE, MA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dryer knob Cracked
Easy as 1 2 3. 1 Ordered Part Received in 3 days Great Service 2 Used Scissors to open the package (not tough to do) 3 Used 1 hand to put the knob on Works Great !!! Start to Finish 3 min. 16 seconds !!!!
Other Parts Used:
james from FALLSTON, MD
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Control knob broke
Pulled the knob out of the package,went downstairs to basement, put the knob on the dryer, walked away with a fixed product. Took 5 minutes.
Other Parts Used:
Randy from E LIVERPOOL, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
2 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
2
Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
14 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Bob
July 16, 2019
I am attempting to replace the selection nob on my dryer. The numbers shown on this nob are: 175d3296p001 & sh940a. Neither of these numbers match the numbers on the web site that suggests its replacement. Do i order this nob which shows the following numbers: We01x20380 replaces: We1m1034 ?Thank you for your time. bob
For model number GTDP490EDOWS
Hello Bob, thank you for inquiring. Yes, this is the correct replacement Control Knob for your model.
9 people found this helpful.
Was this helpful?
Thank you for voting!
Rufus
February 12, 2018
Hello again, thank you for your quick response but i have a follow-up question regarding the rinse cycle refill. If the water is filled to the correct level on the initial wash, what does that have to do with in-fill valve or the hose during refilling of the washer for the rinse cycle? Is there a in-fill valve for wash and one for rinse? My initial question:---hello,on the rinse cycle, the wash tube not filling up to the "load selection" level. In the case it's happening on all load selection.Is this an indication of the control switch or is there something out of sync with the water reset button?...thx
For model number GTWP 1800H0WS
Hello Rufus, thank you for your question. For appliances manufactured after 2011, there were some efficiency changes to the appliances that all manufacturers implemented. The changes made, result in the rinse cycles not filling up the same amount as the wash cycles do. When the appliance is filling up to wash, the water level will be much higher than when it fills up to rinse. I hope this information helps!
3 people found this helpful.
Was this helpful?
Thank you for voting!
Dennis Barnes
July 22, 2019
Is the timer knob different from the control knobs. And if the timer knob shaft is bad can you replace that or get a new timer thank you.
For model number gtdp490edows
Hello Dennis, thank you for your question. The timer knob is different than the other knobs. The timer knob is PartSelect Number PS8769914. If the timer shaft is broken, or bad the whole timer would have to be replaced which is PartSelect Number PS3654187. I hope this helps!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Marcia Oliver
November 26, 2018
Does this dryer knob fit this model
For model number GTDP200EF4WS
Hello Marcia, Thank you for the question. Yes, this Control Knob is listed for the model number provided. The main Timer knob is Part Number: PS8769913. Hope this helps, good luck with this repair!
Hello,on the rinse cycle, the wash tube not filling up "load selection" level. Is this an indication of the control switch or is there something out of sync with the water reset button?...thx
For model number GTWP1800H0WS
Hi Rufus,
Thank you for your question. It could be the control switch, I would also suggest check your pressure switch and hose, and check your water inlet valve as well. I hope that helps. Good luck with your repair.
Was this helpful?
Thank you for voting!
Deborah
August 19, 2019
I’m actually looking for the timer knob if i put a control knob on the timer part of the dryer it simply strips out. Do you have a specific “timer knob” so that i can set the drying time on my dryer? Please let me know i’m having a terrible time finding this part.
For model number GTDP490ED0WS
Hello Deborah, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number PS8769914. Hope this helps!
Was this helpful?
Thank you for voting!
Jay
September 11, 2019
My knob and the black stem part has broken off too how can i get that fixed
For model number gtdp490ed2ws
Hi Jay, thank you for your question. You would have to replace your knob and the switch behind the knob you are replacing. The black stem that you knob slips on to is part of the switch. Good luck with your repair.
Was this helpful?
Thank you for voting!
Star
September 19, 2019
Control knob not working
Hello Star, thank you for contacting us, In order for us to locate the correct parts and repair information we will require the model number of the unit. Once you have located the model number please feel free to resubmit the question and we will be happy to help you. Look forward to hearing from you!
Was this helpful?
Thank you for voting!
Frances
October 3, 2019
My dryer will not shut off. I purchased a new timer and it did not take care of the problem. I can turn it on and it will dry the clothes but i have to go and shut it off. The dryer only has hot heat so it never moves down to cool.
For model number GTDP490ED7WS
Hello Frances, thank you for writing. This is most likely caused by a faulty Cycling Thermostat, part number PS267926 for your model. You may also want to consider the Door Switch, part number PS2344321. Good luck with your repair!
Was this helpful?
Thank you for voting!
Darby
November 30, 2019
Need a white timer settings knob what is the part number
For model number dwxr463eg5ww
Hi Darby, this is only sold as part of assembly PS1482181. Thank you for your question and good luck with your repair!
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
Affresh dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up that can be unsightly and could affect your dishwasher's performance. Each tablet is designed to clean inside your machine ...
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Affresh® Dishwasher Cleaner is the #1 recommended cleaner by Whirlpool, KitchenAid, and Maytag brands, designed to remove limescale and mineral build-up that can affect your dishwasher’s performance. These powerful table...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS8769914
Manufacturer Part Number: WE01X20380
