GE WD28X10391 - RACK ADJ Assembly UPPER | PartSelect.ca
RACK ADJ Assembly UPPER – Part Number: WD28X10391
( Grid squares measure 1x1 inch )
RACK ADJ Assembly UPPER – Part Number: WD28X10391 RACK ADJ Assembly UPPER – Part Number: WD28X10391 https://partselectca.azureedge.net/Schematics/GE/00111401i03.gif

RACK ADJ Assembly UPPER

Your Price

PartSelect Number PS8756486
Manufacturer Part Number WD28X10391
Manufactured by GE

This part includes the wheels. This part may differ in appearance or color but will function the same as the original.

This part works with the following brands: General Electric.

This part works with the following products: Dishwasher.

Customer Repair Stories

Average Repair Rating: 4.7 / 5.0, 2 reviews What's this?
Sort by:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Warren from Stillwater, MN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
Parts Used:
WD35X20994, WD28X10391, WD28X25960, WD12X10304, WD12X10054, WD12X10391
Top and bottom rack were rusted thru
Bottom rack - slide the old one out, slide the new one in. The rack came came with the wheels, so I didn't use the replacement ones.
Top rack - remove the rail end caps - they will likely break so order new ones. Slide the rack out. Remove the rotating spray arm and then remove all the brackets. I was able to re-use the old brackets and didn't need the replacements. Install the old brackets on the new rack, install the spray arm, and slide the new rack back into the rails. The new top rack also came with wheels installed, so I didn't use the replacement ones. Once the rack is back in the rails, install new rail end caps. Put them in sideways and facing into the washer. Straighten the caps and turn them into place. Be careful with the rail caps - they break easy and are expensive. Make sure they hold the top rack in place, and that's it.
29 of 41 people found this instruction helpful.
Was this instruction helpful to you?
Gabriel from La Mesa, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Screw drivers
Parts Used:
WD28X10391, WD28X25960
The wire cage began rusting
The bottom rack just pulls out so that was an easy replacement. The upper rack required a 1/4" nutdriver to remove the sprayer from the rack and a slot screwdriver was used to remove the tab that was holding the rack to the slide arm. Total time, 10 minutes tops!
12 of 17 people found this instruction helpful.
Was this instruction helpful to you?