Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Fred L - November 2, 2018
Verified Purchase
REPLACEMENT ICE FUNNEL
My fridge has a model number of PIR23MGTABV. The Parts Select website shows the ice funnel as PS 12304413 and "no longer available". After discussions with both Parts Select personnel and GE folks it was concluded that there just was no replacement option. After looking at pictures on the internet for part number WR17X11267 I took a chance and ordered it from Parts Select (i.e. the one in this review). It is an exact match so I would suggest that Parts Select show this as the replacement part for this fridge. As an aside, the recommendation on the internet/YOUTUBE, etc of "thawing" the water line going to your fridge with a hair dryer should be avoided because you will undoubtedly melt your ice funnel and need to replace it lol!
★★★★★
★★★★★
Gerald P - February 3, 2022
Verified Purchase
great part just like the original part.
Ice funnel was actually what I needed & thanks for the part. Still have a problem with a leaking hose. Waiting for a new one. Had trouble finding hoses. Gerry
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 4.2 / 5.0, 10 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Ice Chute Flapper not closing causing water dripping to floor and ice chute freezing up solid
I followed the video instructions for replacing the Flapper Valve and solenoid that Part Select suggested. It was one of the best DIY Reapair Sites I've used. Thank you
Removed outer trim by pulling it carefully out of its clips. Then disengaged the electronic display card by grabing the bottom of the card to disengage the card from the upper clips. I leaned the card forward and disconnected the wire connectors. Removed the 4 screws to take off the frame that contains the funnel. Remove the broken funnel from clips. Note study how the spring is engaged. Note position of the rubber funnel how there is a gap for the water tube. Removed the rubber funnel and attached to new funnel dispenser. Start at one end of the rubber flap and work around engaging the rubber into tabs. Replace the Funnel dispenser back into frame. Make sure the longer wire of the spring sits flat on the plastic frame and that the right elbow of the spring raps around the edge of the funnel. Secured the frame assembly back into the Refig using 4 screws and attached out trim starting withe bottom tabs engaged first.
Other Parts Used:
David from Sparks, NV
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
53 of 94 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Trying to defrost the water line in the refrigerator door I melted (deformed) the plastic parts.
I carefully removed the trim from around the dispenser area then freed the catches in the top of the electronic card. I leaned the card forward and disconnected the electrical connections, then removed the card. I removed the four screws holding the shield to the door and removed the shield. Then I removed the funnel from the shield and removed the spring from the old funnel and placed it on the new one. I removed the light and socket from the old shield and installed the in the new one, then installed the new funnel on the new shield, used the four screws to install the assembly on the door and replaced the trim piece.
Melted Dispenser Housing Shield with hair dryer trying to thaw out frozen water line
Pull plastic trim piece off refridgerator door,unclip printed circuit board and remove wires unscrew dispenser housing,and remove. Transfer Ice funnel to new dispenser housing with old spring. Reinstall dispenser housing and printed circuit board.
Followed video for replacing the ice chute flap solenoid replacement because getting to the ice funnel took same steps of disassemble. Looked at how the existing funnel was set in the housing, where and how one spring was located, where the switch and its activating arm on the ice funnel were located, took old one out and put new one in. Cleaned everything in process.
Service Tech Melted the funnel and housing for the ice maker
The trim, funnel and housing were removed. I exchanged the small electrical part to the new housing and reinstalled the housing, funnel and trim. It took longer to get the tool then it took to make the repair.
Mostly cosmetic, ice funnel broken, not dispensing water
Just look at the parts diagram and follow the explanation. That easy. Still not dispensing water, so i think i need a switch since the water filter is new but no water.
Ice funnel was broken and didn’t dispense water or ice
Used a YouTube video with step by step directions, this made the repair very easy.
Other Parts Used:
Jennifer from EDMOND, OK
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The indoor water occasionaly stops working due to the waterline in the door freezing.
I applied heat to the area with a hair drier. Used a little too much heat and deformed the ice funnel which also controls the water spigot. Ordered a new ice funnel from PartSelect. Part arrived in about a week and included a schematic of the mechanism which made disassembly and reassembly very easy. In a short time everything was working like new.
Other Parts Used:
Randall from NORTHFIELD, MN
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
2 of 3 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
11 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Robert
December 17, 2017
Does the spring come with ice funnel?
Hello Robert,
Thanks for your question. The spring is sold separately from the ice funnel and is dependent on the model number for an exact part.
I hope this helps.
2 people found this helpful.
Was this helpful?
Thank you for voting!
William
December 13, 2018
The water/ ice will not stop running unless I lock the dispenser or gently move the control lever around until it stops. Have already replaced solenoid and going to replace the springs on ice chute.
For model number PS123SGRBSV
Hello William, Thank you for the question. You may have a defective Dual Inlet Water Valve, PartSelect Number PS304374. The valve can become stuck open and allow water to continued to flow through. You can also test the Micro Switch, Part Number: PS8259956 for continuity with a Multi Meter. Hope this helps, good luck with this repair!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Daisy
February 27, 2020
How to install ice funnel
For model number GSL22JFTA bs
Hi Daisy, thank you for your question. We do not have an installation video for your appliance specifically. However this video will show you how parts like this are generally installed: https://www.youtube.com/watch?v=p-JUZCh2zGU. That should help you with your appliance as well. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Fred
February 19, 2018
Will not dispense water what could be the problem
For model number GSH25JSDDSS
Hi Fred,
Thank you for your question. I would first suggest checking the water inlet valve with a multi meter to be sure that part is working correctly. If that part is fine you may need to also check your dispenser door solenoid and your micro switch. Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Frank
March 17, 2018
The flap on ice maker is not opening and closing properly. Therefore, when i dispense ice it all gets blocked in the funnel behind the flap. So i have to open the freezer door and push the ice manually down the opening causing the flap to open. If i dont the ice stays there blocking ice behind it from dispensing.
For model number GSL25IFRFBS
Hello Frank, Thank you for your inquiry. We would recommend checking the following parts to fix your issue: the recess door spring, dispenser door recess crank, and dispenser door solenoid assembly-which is what actually opens and closes the flap. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Thomas
September 27, 2017
Water constantly drips from tube at dispenser. What controls the water flow. Is it the funnel that you push in to dispense water?
For model number GSL25KGRBBS
Hi Thomas,
Thank you for your question. Actually that would be your water inlet valve that controls the water flow. There are two solenoids on your water inlet valve. One for the water and one for the ice maker. I would suggest checking the one for your water. It could be that it is malfunctioning. I hope that helps! Good luck with your repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Roger Smith
February 15, 2018
My ice maker will not stop running. It doesn't make ice all the time but it does run all the time.
For model number TFX24ZRS
Hello Roger, thank you for your question. If the icemaker is running all the timer, and won't shut off, I would recommend replacing the icemaker itself. The icemaker has its on motor module that runs like a timer to fill, freeze, dump, repeat. If this motor module is not shutting off the whole icemaker should be replaced. This is part number PS1993870. I hope this helps!
Was this helpful?
Thank you for voting!
GARY
September 18, 2021
Does the ice funnel #wr17x11267 fit my refrigerator
For model number PFSS9PKYASS
Hi Gary,
Thank you for your question. This ice funnel is not listed under your model number. The funnel for your refrigerator is sold with the ice chute door and funnel assembly. The part number listed under your model number for the ice chute door and funnel assembly is PS2359937. If you would like to place an order for it, you may order it either online or by calling our customer service line and anyone will be happy to assist you. We hope this helps! If you have any questions, please let us know.
ice dispenser working, water dispensing is not. So far replaced water dispensing valve. What is the problem?
For model number PGCS1RKZ
Hi Clayton,
Thank you for your question. If your refrigerator is not dispensing water and you have replaced the water inlet valve, there are some other parts that you will need to check to see which one is causing the issue. You will also need to check the water filter, the dispenser door solenoid, the microswitch and the dispenser control board.. We have included a link that you may reference on how to check these parts. Once you have determined the part you need, please feel free to call customer service. We are open 7 days a week and anyone will be happy to assist you. We look forward to hearing from you!
The rubber ring around the outside of the dispenser came off. Now ice splays our wide. Does this part fix that and fit my model?
For model number ZISS480DRKSS
Hi Emily, thank you for your question. Your funnel does not have a rubber gasket on it. The rubber portion is actually part of the ice door which I have listed below for you. Good luck with your repair.
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
Affresh dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up that can be unsightly and could affect your dishwasher's performance. Each tablet is designed to clean inside your machine ...
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Affresh® Dishwasher Cleaner is the #1 recommended cleaner by Whirlpool, KitchenAid, and Maytag brands, designed to remove limescale and mineral build-up that can affect your dishwasher’s performance. These powerful table...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS652226
Manufacturer Part Number: WR17X11267
