Ice Maker Fill Tube Assembly

Hello Burt, Thank you for the question. I suggest checking to see if the fill tube is place correctly first. If it is good you can see if the water lines have froze over causing a blockage and preventing the water to flow properly and dribble tot he ice bin opposed tot he ice maker. You can also check the water pressure to the appliance. If the water pressure is good you may need to replace the Water Inlet Valve PartSelect Number PS7784017. Hope this helps!

Hello Robert, thank you for writing. Mold develops on wet or damp surfaces, more commonly in places with limited airflow and direct light. To get rid of the mold in your dispenser, flush the whole area with chlorinated water. Remove the dispenser cover and clean the inside of the dispenser thoroughly with mild detergent followed with a dilute chlorine bleach solution, afterwards flushing the area thoroughly to remove any chlorine residue that may contaminate the water. Also, remove the water filter and flush the water tubing with chlorinated water. Go through this process every few months to reduce the risk of future mold. We hope you find this helpful.

Hi Minerva, Thank you for your question. The part number for the water filter is PS3412266. I hope this helps. Thank you and have a great day!

Hello Jerry, Thanks for your question. This could be an issue with the water inlet valve, part number PS7784018. You may wish to examine it for signs of cracks or damage, and test it with a multimeter for electrical continuity if you have one. Replace it if it is damaged or shows no continuity. Consider checking the fill tubes as well for signs of damage. I hope this helps.

Hi Bob, thank you for the question. First, you may need to make sure that the water filter is not clogged and also the water lines are properly in place. If that is not causing the issue, then you may need to check the water inlet valve, part number PS7784018, as it is the most likely cause of this issue and may need to be replaced. We hope this solves your problem!

Hello Michelle, Thank you for your inquiry. We do show that this tube runs from the water inlet valve up to the back of the refrigerator into the ice maker, but sadly, we do not have the length of the tube. However, we do not show it as compatible to the model number you provided. The compatible tube for your model is PS12584835 and measures 68 inches long. The complete assembly is part# PS12584840. We hope this helps.

Hello Debbie, Thank you for the question. I suggest checking to make sure the Fill tube is secure and did not get pushed back. Also check the tube for damage or cracks. We hope this helps!

Hello Bill, Thank you for the question. If the ice maker is the only area with the Odor, I would suggest removing ti and cleaning and sanitizing it. You should be able to get a special Ice Maker cleaner as well from a local hardware store. Hope this helps!

Hi Celeste, Thank you for your question. If the ice maker is not getting any water, you will need to check the water inlet valve to see if it is working correctly. A component in it may have failed and you will need to test it with a multimeter. I hope this helps. Thank you and have a great day!

Hello Maria, Thank you for the question. If the ice maker is getting water but not making ice, you may have a defective ice maker and it will need to be replaced. Hope this helps!