Meat Pan Rail - Left Side - White

I pulled the shelf unit out and removed the screw that held in each side. The old rails removed easily and the new ones installed just as easily. I put the shelf back in and slid the new meat drawer in and it was done - much to the delight of my wife. Parts Select has a great website. It was my first time and I read one of these with the exact problem I was having. I ordered the parts, which came quickly. Everything easy and worked great! I'm a happy customer.

A plastic guide rail broke after the meat keeper drawer was left open and the refrigerator door was shut on the drawer, this has happened a few times over the last 6 years. We chose to change out both rails at the same time. We removed the meatkeeper drawer, then the shelf above as the rails are attached to the shelf. We removed the rails (one screw on each side. When the new rails came in, we replaced them with the screws. Super easy!

All I did was remove the drawer, remove one screw. I took out the old slide, installed the new one and replaced the drawer. Quick and easy

Pulled out the drawer, unscrewed the old rails, screwed inthe new rails. It was that simple. The hardest part of the job was removing the food items off of the shelf.

Frigidaire used cheap rail in the meat case, and I expect it to break again. As simple is it to change by unscrewing one little screw, one than spending money to buy the new rail, it will be easy.

My grandson took the old side arms off and replaced it with the new. Everything was so easy and quick. Thank you so much. Joyce

Easy easy easy - take out the shelf above the meat drawer, unscrew one screw that holds in the drawer track, replace the drawer slide, rescrew and replace shelf. Couldn't be simplier... Parts also came very quickly.

Extremely simple. I just pulled the shelf out of the fridge, unscrewed the two screws on each track side. Remember to KEEP the old screws because new screws are
not provided with the tracks. Just screw them in, replace the tracks, replace the shelf and slide in the drawer...
Done!!

The bin door shelf was easy, just snap it in.

For the drawer support rails, the hardest part of the repair was removing all the food from the shelf above the meat bin. Once that was complete, I took out the shelf with the drawer supports, unscrewed the rails from each side, inserted the new rail and reinserted the screw tightening the rail on each side. You can't put the rail in incorrectly since the screw holes will not line up. Very simple and easy.

I pulled out the meat drawer and then emptied the shelf above it. I took out the shelf with the rails attached to it. Then I removed the scre from both sides holing the rails in. I then removed both rails. I took out the spring and device for the cold air on the left side and installed them on the new rail. I then attache the 2 rails to the shelf and inserteed the screws that hold them in place. I put the shelf back in the refrigerator and put the meat drawer back in. I then put all the food back on the shelf.and was done. It was very easy.