Door Shelf Bin

open refrigerator door unsnap & remove old bin. then just snap new bib in place. very simple.

Call before ordering and confirm it is the right part.

It was so easy, I just lifted the old one off and the new went right into place. No tools needed.

New valve is push fittings while old valve is threaded directions don't tell you but cut the tubing and it will match up correctly

Opened refer door and installed shelf Less than 2 min.

Not really a repair story, i only replaced a cracked refrigerator bin. This website is great for ordering replacement parts. I think this is the 2nd refrigerator part I've ordered from the site. Note to self: stop slamming the refrigerator door!

You just have to remove the old parts & replace the new one. Very simple no tools needed.

Un screw 4 screws on ice maker door install new door screw 4 screws
Push to the back on filter and pull of same way instal new one push hard and run water for a bit to clear new filter water
Take some shel push up and push down on new and done 3 new peace’s in less the one hour cots more for 3 parts then replace them

just snapped it in!

Take out old shelf install new.