Water Tube

Hi Laurene, Thank you for your question. First, disconnect power and the water from your machine. Then you will open up both doors. Remove the kickplate from the bottom of the appliance. After removing the kickplate you will see your water line. Put a towel down underneath of it for any excess water. There is a union that connects the two tubes that you will see there. Both tubes are held in with a locking collar. Press down on the collar to remove the tubes. Now you can close your doors. Remove your drip tray. Then remove the screws at the bottom that are holding in your housing. Lift up on the frame of the housing. Then pull the frame out. Do not pull too much. Just enough to get your hand in to disconnect the wire harness from the control board. To do that you just unplug it. Look up underneath your dispenser housing. Use a screw driver or nut wrench to push the water line that you see there up through the opening. Once you have removed that water line, remove the last three screws along the top to remove the rest of the housing. There is a wiring harness on the left hand side. Make sure to unplug that as well. Now that you have your housing out of the way. Carefully pull out the water line. To put the new water tube into your appliance, feed it up through the bottom of your door. Then do these steps in reverse to put your fridge back together. Good luck with your repair.

Hi Ben, Thank you for your question. I have linked that part down below for you. Good luck with your repair.

Hi Roy, Thank you for your question. First it looks like this tube is not the correct tube from your water valve to your filter, it may work if you have the correct unions to connect everything though because all of your water dispenser tubing is 5/16". However if you would like, I have listed the correct part your manufacturer shows down below for you. Unfortunately we do not have information on how to install this part specifically however we have a couple of videos that may help you to figure it out: https://youtu.be/uASszxxtE9w and here: https://youtu.be/u069bgnLrKM . I hope that helps. Good luck with your repair.

Hi Marcia, Thank you for the question. There are a few different areas inside the appliance with tubing that could be leaking. You would really need to investigate to locate what tube needs to be replaces. It is a good idea to check the water filter as well and the filter housing. Hope this helps!

Hi Beth, Thank you for your question. Yes, the tubing would be the same size. The size should be 5/16ths. I hope this helps. Thank you and have a great day!

Hello Chateau, thank you for your question. This is actually a water delivery tube for the icemaker. If the water is leaking from the back of the unit where water flows into the icemaker this could be the issue. I would also check the drain tube that runs from the freezer to the drip tray at the back of the unit to be sure there isn't a blockage. I hope this helps!

Hi James, Thank you for your question. The length of the water tube is 60 inches. I hope this helps. Thank you and have a great day!

Hello John, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number PS429430. Thank you for your inquiry, good luck with this repair!

Hi Robert, Thank you for the question. Yes this is the tube that feeds the ice maker and the water dispenser. If you are replacing both you will need to order two of these tubes. Good luck with the repair!

Hello Frank, thank you for your question. The first step would be to test the valve that sends water to the icemaker to be sure that its functioning properly. Here is a link that will tell you how to do that. https://www.partselect.com/Refrigerator+test-water-valve+repair.htm. If the valve is ok and there is no ice clogging the water tube that runs to the icemaker, the icemaker should be replaced. I hope this helps!