Part Location Diagram of 131076600 Frigidaire FILTER
See part 17 in the diagram
( Grid squares measure 1x1 inch )
Customer Service Representative

Get in touch, we're here to help!

Monday to Saturday
8am - 9pm EST

customerservice@partselect.ca

FILTER

$74.28
  Special Order
PartSelect Number PS416819
Manufacturer Part Number 131076600
Manufactured by Frigidaire
Troubleshooting
This part works with the following products:
Washer, Washer Dryer Combo.
This part works with the following products:
Frigidaire, General Electric, Kenmore, Gibson.
Part# 131076600 replaces these:
AP2105967, 406327
Back to Top
Customer Repair Stories
 Average Repair Rating: 2.0 / 5.0, 1 reviews. What's this?
  • 1
Sort by:
Sorry, we couldn't find any existing installation instruction that matched.
Noisy spin cycle
1) Unplugged washer and disconnected the hot and cold hoses.
2) removed the 2 phillips screws at the bottom of the front panel then removed front panel, you need enough clearance by the floor, this is tricky because you have to lean washer back and push down on the front panel.
3) removed the agitator from the washer
4) lifted top of washer and leaned back against the wall and removed the splash tub cover one clip at a time with a flat screw driver.
5) removed the trunion, this is difficult and will take some time due to the corrosion from many years of use use a hammer (3Lb short handle) and tap one side then the other. You will need to rock it back and forth awhile.
6) lift the basket out of splash tub
7) I removed the hose for water level and removed the 3 bolts that hold the splash tub to the three base mounts (support arms).
8) remove the splash tub
9)change the plastic washer that is between the splash tub and the transmission in the bottom of the splash tub
10) change the bearing(metal sleeve) on the bottom of splash tub and lightly grease w/ a thin film of teflon grease
11) install splash tub and install the 3 bolts along w/ the water level tube
12) install the larger seal (w/ spring in it) and push into the splash tub firmly
13) use some tub and faucet silicone grease on the smaller seal because you don't want to damage this main seal, install the main seal (sits on top of the larger one that's in the tub already) be careful when getting to flat part of the shaft when installing ( spin around the shaft as you pass this point) it will keep the seal from coming out.
14) install trunion (sits down on top of the seal) you will feel the tension of the spring when bolting the trunion back into place.
15) install basket and bolt it to the trunion (I installed a new filter on the bottom of the basket and required some special glue, ask for "3M" GMGA600 adhesive.
16) installed splash tub cover, agitator and front cover.
Washer works great and is quieter than it was new.
Other Parts Used:
Upper Spin Bearing Washer Tub Seal Assembly Spin Bearing Outer Tub Upper Outer Tub Cover
  • Patrick from Humble, TX
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    More than 2 hours
  • Tools:
    Screw drivers, Socket set
138 of 164 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
  • 1
Questions and Answers

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

1 question answered by our experts.
  • 1
Sort by:
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Rhonda
October 7, 2019
How do I remove and clean the filter?
For model number FWX233RES4
PartSelect logo
Hi Rhonda, Thank you for your question. The washer lint filter should be cleaned 4 times a year. To clean the filter, soak it in a solution of hot water and dish soap to allow any residue of laundry detergent and fabric softener to disolve from it. Once cleaned and dried, you can install it back in the washer. I hope this helps. Thank you and have a great day!

Was this helpful?
Thank you for voting!
  • 1
Related Parts
Model Cross Reference
This part works with the following models:
PartSelect Number: PS416819
Manufacturer Part Number: 131076600
Brand
Model Number
Description
Kenmore
41798702890
Washer Dryer Combo
Kenmore
41798702891
Washer Dryer Combo
Kenmore
41799570110
Washer Dryer Combo
Kenmore
41799570120
Washer Dryer Combo
Kenmore
41799570130
Washer Dryer Combo
Kenmore
41799570140
Washer Dryer Combo
Kenmore
41799570150
Washer Dryer Combo
Kenmore
41799570810
Washer Dryer Combo
Kenmore
41799576110
Washer Dryer Combo
Kenmore
41799576810
Washer Dryer Combo
General Electric
52750
Washer
General Electric
52750-4
Washer
General Electric
52750-5
Washer
Frigidaire
F22C233ES0
Washer - Residential
Frigidaire
F22C445ES0
Washer - Residential
Frigidaire
FLXE52RBS1
Washer Dryer Combo
Frigidaire
FLXE52RBS2
Washer Dryer Combo
Frigidaire
FLXE52RBS3
Washer Dryer Combo
Frigidaire
FLXE52RBS4
Washer Dryer Combo
Frigidaire
FLXE52RBS5
Washer Dryer Combo
Frigidaire
FLXE52RBS6
Washer Dryer Combo
Frigidaire
FLXE52RBS7
Washer Dryer Combo
Frigidaire
FLXE52RBS8
Washer Dryer Combo
Frigidaire
FLXE52RBT1
Washer Dryer Combo
Frigidaire
FLXE52RBT2
Washer Dryer Combo
Frigidaire
FLXE52RBT3
Washer Dryer Combo
Frigidaire
FLXE52RBT4
Washer Dryer Combo
Frigidaire
FLXE52RBT5
Washer Dryer Combo
Frigidaire
FLXE52RBT6
Washer Dryer Combo
Frigidaire
FLXE52RBT7
Washer Dryer Combo
Customer Service Representative

Get in touch, we're here to help!

Monday to Saturday
8am - 9pm EST

Contact Customer Service