Whirlpool 9754006 - INSULATION | PartSelect.ca
https://partselectca.azureedge.net/Schematics/Whirlpool/P8HVGSRC.gif
See part 18 in the diagram
( Grid squares measure 1x1 inch )
https://partselectca.azureedge.net/Schematics/Whirlpool/P8HVGSRC.gif

INSULATION

Your Price

PartSelect Number PS403334
Manufacturer Part Number 9754006
Manufactured by Whirlpool

This part works with the following brands: KitchenAid, Whirlpool, Inglis.

This part works with the following products: Range.

Customer Repair Stories

Average Repair Rating: 3.4 / 5.0, 1 reviews What's this?
Sort by:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Gloria from Melbourne, FL
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Wrench set
Parts Used:
WP9781593, 9754006
Inner Oven Door Shattered during cooking.
First, layed tape across all broken glass to keep glass from shattering more and releasing more bits of glass. Pull up and out the oven door. Had table set aside covered with an old sheet to lay door on, After laying door on table, Removed outer screws. Needed phillips #2 & #3 tip widths and electric screwdriver, for inner screws that where difficult to remove. Making notes of what came off first! ( (rt & left, bottom,/top) when removing metal frame braces, and in what order they go in when reassembled . Did the same with screws & set them aside in groups. Then marked the groups of screws. Removed the metal door panel. Carefully removed the in between panel of glass. Set Outer glass aside along with metal "door"and inner door glass,and proped them up in a safe place. Carefully removed the broken & shattered inside glass wearing rubber gloves. Had a garbage can next to the table to with news paper to wrap glass. Cleaned area. Replaced glass taking care not to tighted screws so much as to break the glass. Put added insulation.(Whcih was not the same as in diagram), around the edge. put back the inner glass panel, care not to leave prints, tighten screw ( care not to break glass) Cleaned the door sides and bottom, all had alot of grease buildup.
Put back the metal door portion. Cleaned the outer glass door front and back. Being careful not to break it (or leave prints inside). Replaced the side and bottom metal frames. Wiped it down and put door back on stove.
46 of 50 people found this instruction helpful.
Was this instruction helpful to you?