Igniter MEE61841401

Hello Brad, thank you for your question. We would recommend testing the igniters and the oven temperature sensor first. If those parts are not faulty you should check the gas and safety valves. I hope this helps!

Hi Kevin, thank you for your question. There are a few parts that could cause this issue in your appliance. First I would say test your igniters with a multi meter to see if they are working correctly or not. They should be reading between 0 - 1100 ohms to be working correctly. The other part you should check would be your oven temperature sensor. That can also be tested with a multi meter and should be reading between 1000 - 1100 ohms. If those three parts are fine however, then the issue may be in your control board or the spark module. I hope that helps. Good luck with your repair.

Hello Tom, thank you for your question. If the sensor has been replaced but the oven isn't heating as it should we would recommend testing the oven igniter and the oven gas valve first. If those parts are tested and are working properly you may have an issue with the electronic control board. I hope this helps!

Hi Tom, Thank you for your question. It is normal for a gas oven once it reaches the desired temperature, to turn off after the oven has reached its desired temperature before shutting off while maintaining a consistent temperature. If it is cycling on and off too quickly the issue is usually a weak igniter. If your wife is the banging the door the issue could be the door switch depending on the model of your stove and it may need to be replaced. I hope this helps. Thank you and have a great day!

Hello Barbara, thank you for contacting us. We would recommend testing the temperature sensor and the igniter for continuity using a multimeter to pinpoint the faulty part. According to our data, the temperature sensor, part number PS11732697, is the most likely culprit followed by the igniter, part number PS3535362. Please reach out to customer service if you need help placing an order, anyone will be happy to assist you. We hope that helps.

Hi George, Thank you for your question. To verify the correct model number for your range, you will need to check the model number on it. We have included a link that you may reference on where to locate the model number on your range. We hope this helps! If you have any questions, please let us know.

Hello Doug, Thank you for the question. If the igniter (Plain Heater) is not lighting/glowing it will need to be replaced. Thank you for your inquiry, good luck with this repair!

Hi Shirley, Thank you for your question. If your stove is not igniting, then the issue is the igniter and you will need to replace it. We hope this helps! Good luck with the repair!

Hi Charles, Thank you for your question. The part number listed under your model number for the oven igniter is PS3535362. Where it is listed under your model number, it would be the correct part for your oven. From time to time the manufacturer will update the parts used on their appliances. If you have questions regarding the igniter, you will need to contact the manufacturer. If you have any questions, please let us know.

Hi Chuck, Thank you for your question. If the oven is not heating correctly, then the issue is likely with the oven sensor, sometimes called the oven thermostat, and you will need to check it with a multi-meter. When testing the sensor with a multi-meter, the sensor should be tested at room temperature and it should be unplugged from the oven. You will need to measure the resistance between the two prongs at the end of the sensor connector. Replace the oven sensor if the reading is less than 900 Ohms or more than 1200 Ohms. If this checks out fine, you will need to check the electronic control board, both oven elements and the wiring between these parts to see which once is causing the issue. We hope this helps. Thank you and have a great day.