The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.
Note: This part has been updated by the manufacturer. It may differ in appearance but will still function the same as the original.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Dan B - July 10, 2020
Verified Purchase
Not as simple as it should have been
As stated the part has changed, I was replacing one that was about 10 years older, but listed as compatible. The connection points on the starter are different from the leads on the fridge. Had to remove some plastic and solder them together. The part does work though!
★★★★★
★★★★★
Doug O - January 1, 2020
Verified Purchase
Great
Fixed my fridge that wasn’t getting cold
★★★★★
★★★★★
Jeremy N - October 9, 2018
Verified Purchase
Part slightly different then one in photo
The part in the photo would have been a perfect fit for what I needed. But the part that came was slightly different. Where the plug connected to this part, the prongs were larger than what was being replaced. So my plug would not plug into this new part. I had to take apart the old part and remove the smaller prongs and then take apart the new part, and switch prongs. The part still worked, but involved an extra hour of time to make the part work.
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 4.0 / 5.0, 6 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
there is electrical surge from Pacific Gas and electric.
There is PG and E employee working in one of the electrical post that cause the electric surging,there is a 3 big bang then we smell burning wire.it blew and burned the compressor relay,so what i did is figure it out, all 2 refregirator fan is running the heater is working,but its not cooling, when I touch the compressor there is no vibration,so all i did is removed the compressor relay, and I found out that the wire is burned and melted the connector, i order the relay from parts select and install it.1.remove the capacitor and install it to the new relay. 2.put a new connecrtor from the wire.3. install the compressor relay.easy as 1,2,3.
Other Parts Used:
Reynaldo from SAN BRUNO, CA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers, Socket set
7 of 11 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
It was making a clicking, chirping sound every two minutes
Took me weeks to find the noise after I checked everything electrical in the house including replacing all batteries. Finally, an electrician isolated it to the refrigerator.
Frigidaire Model FRS26LH5DS9 Found several YouTube videos for reference.
Replaced the Run Capacitor and Compressor Start Relay.
Unplug and remove the back panel. On the bottom left side, detach the two old parts together from the compressor. Use a large flat screwdriver to pry them out. (They are held in place with a wire you must first remove.) Plug one new part onto the other and then insert it as one part.
Easy Peasy. The hardest part is getting your hand in a small space and putting back the wire that holds them in.
I had a repairman here and after spending 350 dollars after 4 visits and parts, I decided to try it myself. I ordered a compressor start relay and a run capacitor. Replacement took all of 15 minutes and now runs again for the first time in a month. Thank you Parts Select. You’re the best!
Unplugged freezer, used digital multimeter to test defrost thermostat, temperature sensor, start/run capacitor and start/run relay for compressor motor. Found ohms values for start/run capacitor to be out of range and carbon traces on relay base where capacitor connects. Replaced capacitor and relay. Plugged freezer in and compressor immediately started running. On mid-range temp setting, empty freezer, temperature alarm light went off in 3 hours. Freezer has been functioning properly since repair was made. My husband is a licensed elevator mechanic with a background in electrical troubleshooting. He tested the components and completed the repairs.
Compressor not running, freezer and fridge warming up
Tested the start relay and capacitor with a multimeter and determined they were both bad (thank you, YouTube!). Ordered both here and they arrived in 4 days. It took me less than 15 minutes to install both; the appliance is working better than ever! The parts were very easy to access and replace.
The housing is not the same where the wires attach. I had to cut off the plastic shroud around barbs on start relay to accept the original larger wire end Fittings.
Other Parts Used:
Robert from GULF SHORES, AL
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers
1 personfound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
13 questions answered by our experts.
< Prev
1
2
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Scott
October 1, 2017
When compressor tries to start up there is a click after 3-4 secs and then it shuts down...after 3-5 mins repeat
For model number FRS26BH6CS5
Hello Scott, thank you for contacting us. This would be the start relay. Good luck with the repair!
8 people found this helpful.
Was this helpful?
Thank you for voting!
Joseph
December 2, 2017
Fridge sounds like it wants to start. Will click and surge to start for up to three minutes. Starter relay?
For model number PLHS269ZCB3
Hi Joseph, Thank you for the question. It would be the Start Relay, Part Number: PS3502347 or the
Run Capacitor, Part Number: PS3495561. The Capacitor helps the compressor kick on and off and the start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed. You can replace both parts or test them with a Multi Meter to check for correct resistance. Hope this helps!
4 people found this helpful.
Was this helpful?
Thank you for voting!
Terry
September 21, 2017
Every time my fridg. Wants to Star up, it like surges power for about 10 minutes ( 2 seconds on then 2 seconds off) before the motor stays on full pushing the cold are out. Is this the part i need? Normally the fridg. Would just start up at first try.
For model number FRS26H5ASB9
Hi Terry,
Thank you for your inquiry. Yes this part should fix the issue. I hope this helps. Thank you and have a great day!
4 people found this helpful.
Was this helpful?
Thank you for voting!
Tim
September 23, 2019
I have been given the following part number for the repair 4387913, but the part looks identical the part that I found here for the question that I am asking on. I would like the overload relay, capacitor, but the part number referenced above makes me a little nervous to order it since it looks so different than the one that I found.
For model number 106.63289301
Hi Tim,
Thank you for your question. This would not be the correct start relay device listed for your refrigerator.
The part number listed under your model number for the compressor start relay is PS12584621. I hope this helps. Thank you and have a great day!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Candido
November 28, 2019
What starter relay number is compatible to that Kenmore refrigerator model. The relay i have here has number 297259507 (this is busted).
For model number 970R424133
Hello Candido, Thank you for the question. Sadly, we do not have any information on the model number you provided. Could you please verify the number you provided us with? If it is correct, I recommend contacting the manufacturer and seeing if they could provide you with a part number, and then you are always welcome to check back to see if we carry the part. Hope this helps!
1 person found this helpful.
Was this helpful?
Thank you for voting!
Roger
June 17, 2022
The freezer quit freezing. Stuff thawed out. Sounded like it was having a hard time kicking on. Compressor out?? Or Relay??
For model number Fridgedaire Gallery
Hello Roger, thank you for your question. The Relay PS3502347 or Run Capacitor - 120V PS3495561 are the culprits. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you.
Hello Pamela, thank you for asking. According to our research, you may need to check the compressor start relay, part number PS4704897, to fix the issue. We hope this helps!
Hi Shelia, thank you for your question. You should just be able to unplug them however if it is a little too secure you can use a flat head screw driver to help push the wires from the terminals. Good luck with your repair.
Was this helpful?
Thank you for voting!
Tom
January 18, 2020
The freezer motor keeps turning on and off...it blows cold air but struggles to stay on. will this part fix the issue or any other suggestions
For model number plhs269zcb3
Hello and thank you for writing.
It certainly sounds like it could be a faulty run capacitor PS3495561 and/or possibly a faulty start relay PS3502347, you should check for signs of damage, and replace if necessary. We hope this helps. Please contact us anytime if you require further assistance.
Is there a trick to getting the plug out of the old one? We are afraid to break it in case the old part is fine.
Hi Trish, thank you for your question. You should just be able to unplug them however if it is a little too secure you can use a flat head screw driver to help push the wires from the terminals. Good luck with your repair.
Was this helpful?
Thank you for voting!
< Prev
1
2
Next >
✖
Ask a Question
Ask our experts a question on this part and we'll respond as soon as we can.
This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. The run capacitor is attached to the compressor. This part is 120 volts and 15 mfd. The run c...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS3502347
Manufacturer Part Number: 297237702
