Drying Rack

Hello Megan, Thank you for contacting us. I have researched the model you have provided and have found the part you’re looking for is PartSelect Number: PS11769196. Hope this helps!

Hello Meagan, Thank you for writing. Sadly, the part you are requesting we do not have listed for your model. We strongly recommend you contact the manufacturer, as they would have this information in their system. Ask them for the part number you require and contact back to see if it is something we carry. Hope this helps!

Hello Heidi, thank you for your question. The drying rack for this unit is PartSelect Number PS3521801. Please enter the part number into the site for current price and availability. Good luck with your repair!

Hi David. The part you are looking for is linked below. Thank you for your question and good luck with your repair.

Hello Dina, Thank you for contacting us. We have researched the model you have provided and have found the part you are looking for is PartSelect Number PS346849. This dryer rack fits dryers that are 29 inches wide, have the letter "E" following the numbers in the model number, and whose dimples are four and a half inches apart in the back of the dryer drum. Very sorry, we do not have a diagram for instillation at this time,. just for basic part location. If you need help placing an order, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!

Hello Donna, thank you for your question. Yes, the Rack PS346849 you had chosen is compatible with your model. Please feel free to give us a call. We look forward to hearing from you.

Hello Doug, thank you for the question. To replace the blower assembly, please follow the following steps: 1. Un-thread the screws and slide the top panel back, then lift it up to detach. 2. Remove the control panel and disconnect the wire connector from the control board. 3. Lift up the tabs to detach the housing. 4. Disconnect the door switch wire connector. 5. Lift up and detach the front panel after removing the screws from the support and bulkhead. 6. Remove the bracket securing the control board. 7. Detach the front support brace. 8. Release the lower support bracket and remove the front bulkhead mounting screws. 9. Disconnect the sensor wire connector. 10. Reach under the drum and un-thread the belt from the pulley and motor shaft. 11. Use the belt to help lift out the drum. 12. Remove the blower cover and remove the blower wheel. 13. Install the new blower wheel and place the blower cover. 14. Reinstall the drum by aligning the rear of the drum on the rollers. 15. Rotate the drum to help align the belt. 16. Reposition the front bulkhead on the drum and hook it on the cabinet tabs. 17. Reconnect the sensor wire connector and secure the bulkhead. 18. Reinstall the control board bracket and front panel. 19. Align the panel on cabinet tabs. 20. Connect the door switch wire connector. 21. Insert the control panel housing tabs into the slots in the front panel, and snap the housing. 22. Connect the wire connector to the main control board and realign the top panel, then slide it into position. We hope this information helps!

Hello Josh, Thank you for writing. Sadly, the part you are requesting we do not have it as compatible with your model 11061202011. We strongly recommend you contact the manufacturer, as they would have this information in their system. Ask them for the part number you require and contact back to see if it is something we carry. We hope this helps.