Washer Inner Tub Filter Plug Kit 285868

Hi Rocky, Thank you for your question. To get to these parts you have to remove your agitator. Once you remove your agitator you will see 4 holes. If you have two holes that are bigger than the other two, that is the only place where you will replace these parts. The smaller holes do not have the filters. Good luck with your repair.

Good Day Lindsey. Thank you for your question in regards to your unit (Model Number LSR8233JQ0). Unfortunately we were not able to locate information on this for you and would recommend reaching out to the the manufacturer for further assistance. They can be reached at by phone by calling 866-698-2538. Best Regards.

Hi Gerry, Thank you for your question. The diameter of the hole these filter plugs are inserted into would be approximately 1 inch. Your washer may use all 4 plugs or just 2 of them. These plugs and the filter help to keep your washer functioning properly. If you would like to place an order for them, please call our customer service line and anyone will be happy to assist you. We look forward to hearing from you!

Hi Dan, thank you for reaching out. Yes, to clean the filter, you have to unbolt the agitator all the time as it sits under the agitator. You may need to follow these steps to access the filter: 1. Disconnect your power source and open the washer door. 2. Take out part of the agitator and the small cap that is inside. 3. Use the socket to spin the agitator to loosen it. 4. Pull the agitator out. 5. Now you have access to the filter and you can clean it. We hope this information helps!

Hi David, Thank you for your question. Unfortunately you would just have to clean them out any way that you can. You could try with a vacuum. Make sure that your appliance is unplugged before doing any in depth cleaning with it. Just in case. I hope that helps. Good luck with your repair.

Hi Michelle, Thank you for your question. If you have lint left on your clothes, check the ling trap and clean any excess lint from the trap and the exhaust hose. If there are marks left on the clothes, there are some parts that you will need to check to see which one is causing the issue. Here is a link from our website that you may reference on what parts to check, https://www.partselect.com/AdvancedModelSymptoms.aspx?ModelNum=LXR7144EQ1&mfgModelNum=&fkMfgID=3&ModelMasterID=64090&PID=45. I hope this helps. Thank you and have a great day!

Hello Tom, thank you for your question. Sometimes, if you use a rope or a ratchet strap and slide it under the agitator it can help give you some leverage for pulling up on the agitator. I hope this helps!

Hello Leah, thank you for your inquiry. Yes, you may need to snap the filter plugs into the 4 holes with the hard gray piece of plastic below the drum. We hope this information helps!