The right front burner control was broken and would spin freely 360 degrees. After my ordered part arrived,I shut the gas supply off to the stove and lifted the stove top up to expose the gas feed system. I had to remove all the gas knobs then I removed the front sheetmetal cover that goes over all the burner control valve shafts.With that done I disconnected the gas feed tube from the burner end then the burner valve end and remover the tube. I remover the bad valve, which will have the electronic start switch still attached to it. Gently, but firmly, pull the switch off the burner valve. Push new burner valve into the switch and re-assemble burner valve to the main gas feed manifold. You then reassemble the parts you removed in the reverse order. Turn the main gas valve to the stove ON and check for leaks. If all is OK, lower stove top and try the new valve for proper operation.
needed to repair the door shelf retainer bar and end cap
first I removed the old inside shelf, very easy and then replaced with new inside shelf retainer and end caps, which all lock into each other and make the process quick and easy.
I am the manager/super of a rental sixplex. Tenants are tough on realty. Tenants try to force too much on the doors. Consequently they damage property. With a small screwdriver I pushed the retaining tabs, snap in the new bracket and repair was complete. I have used PartSelect many times for parts for this rental and other properties we are responsible for and have always been pleased with the whole process. From shematic, part selection, ordering, delivery and installation, I have been very happy and continue to use PartSelect as a resource to keep my world spinning on its axis.
Inserted front door shelf into retainer end cap and put into door. The other one was harder but was easy once the bar was out of the door to replace it with the new one.
Opened the box delivered by FedEx and placed the door shelf retainer bar end caps in the left and right side and inserted the bar.
Whomsoever, put the retainer in when delivered did not secure it and it had always been loose. One day some frozen food got in the way of the door closing and broke my retainers. Thus, I am so happy now that they are very secure and in place as they should have been upon delivery.
Snapped end cap onto bar and installed bar onto freezer door.
I considered going to an appliance parts store but found the part very easily on the internet and had it within 2 days. I am very busy which was very helpful.
Other Parts Used:
Kimberly A from Columbus, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
3 of 4 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Broken shelf retainer bar end cap.
I ordered 2 end caps just to keep one as spare. Turned out I had ordered a size larger than the one already on the refrigerator. So I replaced both ends and it worked fine - with increased shelf space. Now I can even fit a gallon container with ease!!! Took about 20 seconds. I just wish there was an easier way to measure parts before ordering. Otherwise, the entire process from order to finish took about 3 days.
Other Parts Used:
Ruchik from Bronx, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
The above door End Cap broke.
The repair just required snapping the new part on to the door shelf and then snapping the shelf in to the door.
Other Parts Used:
John from Northglenn, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Old end cap broke.
Put the new end cap on and snapped it into place, took about 5 seconds.
Other Parts Used:
Travis from North Quincy, MA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
2
Next >
Questions and Answers
Ask our experts a question about this part and we'll get back to you as soon as possible!
2 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Paul
May 13, 2019
I just ordered two end caps for the fridge shelf retainer bar .... but it was not clear if i am getting a right and a left (which is my intention), or two of the same?
For model number Tbh18jasnrwh
Hello Paul, thank you for your question. This replacement Door Shelf Retainer Bar End Cap for your model works on both the left and right side.
6 people found this helpful.
Was this helpful?
Thank you for voting!
Patricia
November 23, 2021
I need a retainer bar end cap for freezer door bar.
The top is larger than the bottom.
Your video shows the top one being replaced.
Can you help. I need part for smaller lower shelf. I only see one size
Many thanks
Patricia
For model number TCX18PADBBB
Hello Patricia, Thank you for your inquiry. The smaller 2 inch end caps are part# PS299579. We hope this helps.
