Overlay - Black

Hi Patricia, thank you for your question. That code actually stands for Store Demo. What you have to do is unplug the appliance for about 45 seconds. Then when you plug it back in press and hold the Oven Cook Time button until the SD disappears. I hope that helps. Good luck with your repair.

Hi Ryan, Thank you for the question. The overlay is Peel and Stick with the adhesive backing already on it. Hope this helps!

Hello Bernie, thank you for your question. Yes, that would fix that error code. We would recommend replacing the overlay as well. I hope this helps.

Hello Alex, Thank you for the question. The F14 Error code indicates the user interface panel cable is missing or disconnected. We suggest checking the cables and wiring to make sure nothing is damaged or loose. We hope this helps!

Hello Jim, thank you for your question! F11 error is a shorted key error. It means when a key on the keypad has been detected as pressed in for a long time, the F11 error is reported and all oven commands are terminated. First, simply press the cancel key to clear the code. The error may have been caused by just holding down a key too long by mistake. Try to reset the electronics by killing power to it at the breaker/fuse panel on your home for one full minute, then restore power. If the error persists, you will need to replace the overlay, part number PS2364031, and electronic control board, part number PS9494055. We hope this helps, good luck with this repair!

Hello Dawn, thank you for your question. F10 indicates that the control detects a runaway temperature in the oven. If the oven is overheating, this can be caused by a stuck relay or contact on the oven electronic control board. If this fault code appears when the oven is at room temperature, then the failure points to a failed oven temperature sensor probe circuit or a bad electronic oven control board. If you are able to unplug the range and access the oven temperature sensor, you can check the resistance of this component with a volt/ohm meter. At room temperature, most Frigidaire oven temperature sensor probes will measure about 1100 ohms at room temperature. If your probe measures 2500 ohms or higher, then a defective temperature sensor is causing this problem. If the sensor is okay, then I recommend reconnecting the sensor and checking the resistance through the wiring harness connection directly at the electronic oven control board (with the range still unplugged). The sensor is oven connected through violet wires on Frigidaire ranges. If the resistance is normal through the wires that plug into the control board, then it is likely that you will need to replace the control board. I hope this helps

Hello Doug, Thank you for the question. Yes, the old overlay will work on the new EOC. Hope this helps, good luck with this repair!

Hello Curtis, Thank you for the question. I woudl first suggest testing the oven sensor probe. PartSelect Number: PS11731755. Testing the temperature sensor probe on your oven is easy. With the sensor at room temperature, measure the resistance between the two prongs at the end of the sensor connector. The resistance of the sensor should read approximately 1080 – 1090 ohms at room temperature. If the sensor is good you will need to replace the Electronic Oven Control Board, PartSelect Number: PS9494055. Thank you for your inquiry, good luck with this repair!

Hello Gigi, Thank you for the question. Yes, I woudl suggest cleaning the old Adhesive off in order to reinstall it properly. Good luck with the repair!

Hello Steve, thank you for contacting us, In order for us to locate the correct parts and repair information we will require the model number of the unit. Once you have located the model number please feel free to resubmit the question and we will be happy to help you. Look forward to hearing from you!