Control Panel Frame

The repair was simple. It was just a matter of removing the upper vent grill to access the screws for the panel frame. Then I just popped out the old frame and installed the new..and the micowave is as great as it was new. The PartSelect website allowed me to see a visual map of all the parts of my microwave which allowed me to find and choose the right piece for the job. It only took 5 minutes for the repair.

Removed the grille then able to change control panel frame. Since the outer frame was cracked it was easy to see how to take it apart from there. All told it was a 2 hour job but part of that was taking advantage of the exposed parts and cleaning the microwave throughly. I have to say though this would have gone a lot eaiser with some directions.

The repair was simple. It was just a matter of removing the upper vent grill to access the screws for the panel frame. Then I just popped out the old frame and installed the new one. The PartSelect website allowed me to see a visual map of all the parts of my microwave which allowed me to find and choose the right piece for the job. It only took 15 minutes for the start to finish repair.

Remove air inlet piece with two screws. Remove one screw holding the frame on. Whole keypad with frame is loose though still attached with wiring. Remove old frame from keypad and replace with new and reinstall.

My son did the repair for me. He only had to use a screwdriver. He removed the panel ,took the old on off and put the new one on.

Unplugged the power supply; removed screws; unplugged the appliance at the control panel; cleaned up smudges that couldn't be reached otherwise; replaced the part and replaced the screws. As easy as 1-2-3!