Thermostat

Hi Christine, Thank you for your inquiry. Before beginning any repair please unplug the power cord from the electrical outlet. First, you will need to remove the thermostat knob. This may require some effort. You may have to use some string or some wire to pry it off. Next remove the screws securing the upper back panel and pull the panel off. Remove the mounting screws to release the old oven thermostat assembly. Install the new oven thermostat assembly by positioning it the control panel and securing it with the screws. Transfer the wires from the old thermostat to the new one. Unclip the old sensing bulb and route it out of the cabinet and remove the old assembly. Route the new sensing bulb through the cabinet and snap it into position. Replace the back panel by securing it with the screws. Put the knob back on and plug the oven back in. I hope this helps. Thank you and have a great day!

Hi Angela, Thank you for the question. We do not have a picture sorry, but according to the wiring diagram, the Black double wire goes to terminal 4, white double wire to terminal 5 with a single white to 5. Red wire and brown wire to terminal 1, double red to terminal labeled P1/2, blue wire to terminal labeled 10/7, and yellow wire to terminal labeled P10/6. Hope this helps!

Hi Don, thank you for your question. There are a few parts that could cause this issue in your appliance. First I would say test your elements with a multi meter to see if they are working correctly or not. They should be reading between 0 - 50 ohms to be working correctly. The other part you should check would be your oven temperature sensor. That can also be tested with a multi meter and should be reading between 1000 - 1100 ohms. If those three parts are fine however, then the issue may be in your control board. I hope that helps. Good luck with your repair.

Hi Larry, Thank you for your question. The sensor is attached to the oven thermostat. It is the long silver tube that you see in the photograph. I hope this helps. Thank you and have a great day!

Hello Randall, Thank you for contacting us. I have researched the model you have provided and have found the part you are looking for is PartSelect Number PS1765834. We hope this helps.

Hello Jenny, Thank you for your inquiry. We would recommend checking the following parts to fix your issue: bake element, temperature control thermostat, and double check for any loose or burnt wire connections. Hope this helps!

Hello George and thanks for writing. Thermostat Part Number: PS235122 is in the list of compatible items for your model. We hope this helps. Please contact us anytime.

Hi Marcus, Thank you for your question. If the oven is not heating correctly, then the issue is likely with the oven sensor, sometimes called the oven thermostat, and you will need to check it with a multimeter. When testing the sensor with a multimeter, the sensor should be tested at room temperature and it should be unplugged from the oven. You will need to measure the resistance between the two prongs at the end of the sensor connector. Replace the oven sensor if the reading is less than 900 Ohms or more than 1200 Ohms. You may have to check the electronic control board as well if the sensor checks out fine. I hope this helps. Thank you and have a great day!

Hello Dan, thank you for your question. Yes, this thermostat PartSelect Number PS1765834, is the correct replacement part for your unit. Good luck with your repair!

Hello Tyrone, Thank you for your inquiry. The thermostat establishes and maintains the internal temperature of the oven cavity. If your stove top elements are not heating, then we would recommend checking the element, the burner switch, and the surface burner terminal block kit. You can test the parts with a multimeter. If you are unfamiliar with how a multimeter functions, we have videos available to assist you. We hope this helps and if you need help placing an order for a part, customer service is open 7 days a week. Please feel free to give us a call. We look forward to hearing from you!