Refrigerator Water Filter LT1000P AGF80300704

Hi James, thank you for getting in touch. The water filter is located on the left side of the LED lamps in the interior section. For filter replacement, we recommend you follow the following instructions: (A) For filter removal: 1. If the top shelf, located below the water filter, is in the highest position, it will need to be removed. 2. Pinch the sides to open the water filter cover. 3. Pull the water filter downward and turn it anticlockwise before pulling it out. Make sure to rotate the filter completely before pulling it out of the manifold hole. (B) For filter installation: 1. Remove the new water filter from its packaging and remove the protective cover from the O-rings. With the water filter tabs in the horizontal position, push the new water filter into the manifold hole and turn it clockwise until it stops. 2. Close the water filter cover. The cover will click when closed correctly. After replacing the water filter, dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air and contaminants from the system. After changing the filter, press and hold the Water Filter button for three seconds to reset the indicator light. We hope this is what you were looking for!

Hi Gary, Thank you for your question. The part number listed for the water filter under your model number is PS12724834. We hope this helps!

Hi Douglas, thank you for the question. To install the filter, take the new cartridge out of its packing and remove the protective cover from the o-rings. With cartridge ears in the horizontal position, push the new filter cartridge into the manifold hole until it stops. Firmly lock in the cartridge. The cover will click back into place. We hope this information helps!