Range Oven Burner Igniter W11176454

pulled out the stove and removed bottom drip plates to access the old ignitor. Removed 2 screws after unplugging the two wire ignitor. fished the the two wires thru back of stove and plugged them in where old wires were. put the 2 screws back into the new ignitor and tested before replacing drip plates. been cooking in the oven ever since, no problem.. Part was a perfect replacement.

I removed the oven door first, then pulled the unit away from the wall being careful of the floors. I unplugged the oven, and turned off the gas feed. I worked on the thermostat first. I followed the wiring from the inside of the unit to the back panel, and disconnected the cable. Two philips head screws held in place - swapped it out for the new one - and there you go. Some insulation might also poke out when your snaking the wired through, so just tuck that back in as best you can.
Then I moved onto the igniter. I followed the wiring, and disconnected it at the back panel. The igniter was held in place with two hex bolts ( I can't remember the exact sizing since I just kept going down in sizes until it fit snugly on the bolt head). The metal plate they bolt into was warped, but with a little persuasion from some pliers it was easy to bend for better access to the bolts. Be careful if you are doing this since the bracket is attached to the burner tube and too much torque is always bad for hollow metal parts. Attach and wire up the new igniter, still being careful to replace any insulation that creeps out.
Plug the unit back in.
Turn on the gas feed.
Push it back into place.
Replace the oven door - and there you go.
I had also purchased an oven thermometer that hangs from the wire racking. I had the oven on at 350 for 30 minutes and the temperature never really swayed more than 15 degrees. It also heated up substantially faster.

Removed to igniter, plugged in the new one and I was don’t. Do use care not to touch with bare skin the part that gets hot so you don’t get skin oils on the igniter that can cause it to burn up.

I followed a video on you tube. It was very simple and this was my first time repairing an appliance.