Circulation Pump

Hello Thomas, Thank you for your inquiry. It does sound like your motor, but check first to make sure the impeller and chopper are not clogged. Hope this helps!

Hello and thank you for writing. It does sound like your circulation pump is faulty, but check first to make sure the impeller and chopper are not clogged and your water inlet valve PS11750066 is functioning properly. We hope this helps. Please contact us anytime if you require further assistance.

Hi Steve, Thank you for your question. Here is some information from our website that may help you, "Disconnect the power source to your dishwasher before you conduct this or any other test. Either unplug the unit from the wall outlet, remove the appropriate fuse from the fuse box, or flip the appropriate breaker in the circuit breaker panel. Locate your dishwasher's motor. It will be found behind the lower kickplate/access panel. This panel will be held in place with either two or four screws. Remove the screws you find in order to remove the panel. It may be necessary for you to open the dishwasher door to remove the screws, but then close the door again to remove the panel. Disconnect the motor's two wire leads from the wiring harness. Set your multimeter to the R x 1 setting. Touch each of the meter's probes to one terminal each. Your motor should show little resistance (a reading of zero, or close to zero). Now check the ground connection. Place one probe on the bare metal housing of the motor. Place the other probe on each terminal, one at a time. You should not receive any reading on your meter from this test. If your dishwasher's motor fails either of these tests, you will have to replace it." I hope this helps. Thank you and have a great day!

Hello Rob, thank you for your question. I would recommend removing the filter at the bottom of the tub and cleaning it out well as well as the spray arms. If the spray arms are clogged with debris the water will not be able to spray on the dishes enough to get them clean. If the filter and spray arms are clean and the noise is coming from the pump the pump itself should be replaced. I hope this helps!

Hello Bob, thank you for writing. This is most likely due to a faulty Drain Pump, part number PS11753379 for your model dishwasher. You may also want to consider the Drain Hose, part number PS2358130. Check both for clogs and damage before replacing them. You can test the Drain Pump for continuity with a multi-meter. You should get a reading of zero or nearly zero for it to be functioning properly. Good luck with your repair!

Hi Martha, Thank you for your question. There are 3 motors listed for your dishwasher. The part number listed for the diverter motor is PS5136127. The part number number listed for the pump and motor assembly is PS12074533. The part number listed for the pump motor is PS12070585. If you would like to place an order for one of these parts, customer service is open 7 days a week and anyone will be happy to assist you. Please feel free to give us a call. We look forward to hearing from you!

Hello Jim, Thank you for writing. This can indicate the cycle was interrupted. This can happen when the door is opened during the cycle or power has been interrupted. Push the door firmly closed within 3 seconds of pressing Start/Resume. Check the Door Latch and handle for any wear or damage preventing the door from closing and staying closed properly. We hope this is helpful!

Hello Dan, thank you for your question. This Clamp PS11703368 is 1-1/2 " in diameter. We are pleased to have been able to help.

Hi Jim, Thank you for your question. You may need to check your water inlet valve or replace it. It sounds like there may be something jangling around. Once you remove your inlet hose you may see something there. If you do not and there is still rattling inside the part you will have to replace your valve. Good luck with your repair.

Hi Ben, Thank you for your question. There are some parts that you will need to check to see which ones are causing the issue. You will need to check the drain pump, the turbidity sensor and the heating element. I hope this helps. Thank you and have a great day!