Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing reviews that matched. Try using some different or simpler keywords.
★★★★★
★★★★★
Alex S - September 13, 2020
Verified Purchase
Microwave ceramic fuse on 20A
Original OEM quality with treasonable price
< Prev
1
Next >
Customer Repair Stories
Average Repair Rating: 3.9 / 5.0, 7 reviews.
What's this?
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing installation instruction that matched.
Blows main fuse when the microwave generator start, (cooking function).
Remove microwave from oven cabinet. remove cover and check main fuse with ohm meter. Tried fuse, it does not blow untill cooking starts. Check capacitor with ohm meter, after properly performing capacitor dischagre procedure. Order new capacitor, simple installation. another new fuse and all is good and cooking again.
First I removed upper front grill by removing two Philips head screws on top and pulling off. This exposed the Philips head screw which holds control panel in place. After removing screw I pushed up on panel and it came off to expose fuse. With needle nose pliers I removed old fuse and again with pliers held new fuse in position. With the help of a bladed screwdriver, I pushed new fuse into holder, then replaced panel, screw and grill. This took less than 15 minutes even as one of the wires on control panel pulled out of connection and took some time to locate where to reconnect, otherwise was an easy fix .
Other Parts Used:
tad from tamarack, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
26 of 41 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
microve stopped working
Jenn-Air Microwave would not turn on. Clock worked , light worked, timer worked and would count down .I changed' Part #0813140 Switch, Micr} cost $8.99 plus shippingNow it works Thank You for good advise
Other Parts Used:
Denice from Montgomery, AL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
15 of 26 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Died while heating lasagna
Removed 4 small star head screws from back of microwave, lifted body off, removed blown fuse and replaced with new one (found where cord enters). This model is stainless inside and out and I like it a lot. It is also sold by Daewoo and a few other manufacturers.
Other Parts Used:
connie from madison, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
9 of 16 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Microwave went pop and nothing would work.
I mistakenly thought I had to remove the microwave to get to the back, not so. I would have had access to what I needed to unscrew; but I have to admit the hassle of taking it down and putting it back equals having to work on it attached to the shelf-your call on how you do this. I unscrewed the front top to remove the vent piece that is across the top front of the microwave. This will reveal the control panel screw. (While you have the vent removed you might want to clean the vent and the exposed filter.) carefully lift and pull out control panel. I unplugged a piece as the wires were tied tight. It will not completely detach, so carefully tip it back from exposed insides. The fuse is not clear but white with silver ends so look in upper right for it. I popped it out and replaced it. Replugged the wired part to cover and carefully fit tabs in and slide down to secre. Replace screw, replace vent piece and secure screws on top of microwave. I plugged it in to test before putting it back above my stove.
Other Parts Used:
Deborah from STRUM, WI
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
6 of 8 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Microwave not heating
Replaced diode works great. your website said 92% diode was problem and it worked. Order fuse in case old was blown did not have to use it.
Access is via RT. SIDE Panel as you face microwave. There are three screws on the bottom right edge to loosen. After that the side panel slips down and off. the fuse is located in the rear near where the power cord comes in. It is the white ceramic tube 1/4" in dia. and 1-1/2" long. Pull it out like any fuse and replace with new one. Reassemble and you are done!
Other Parts Used:
Richard from CALIFORNIA, KY
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
2 of 2 peoplefound this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
< Prev
1
Next >
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
6 questions answered by our experts.
< Prev
1
Next >
Sort by:
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Garrett
June 13, 2019
Where is the fuse located?The microwave lights up but no power
For model number rrl-8x
Hello Garrett, Thank you for the question. The fuse is located next to the Capacitor behind the control panel. Make sure your microwave is unplugged, and your capacitor is discharged before you begin this repair. A capacitor stores large amounts of electricity even after your microwave is unplugged. Hope this helps!
2 people found this helpful.
Was this helpful?
Thank you for voting!
Edward
February 26, 2020
I had engaged the cleaning cycle on the oven which is part of this combo unit and sits below the microwave. My wife decided to heat a up of water while the cleaning cycle was in progress. She claims the microwave started for a few seconds when the controls went blank and the microwave stopped working. The oven continued with the cleaning cycle which completed normally. No circuit breakers were tripped in the breaker box. I reset the circuit breaker for the appliance after the cleaning cycle had finished but the microwave continues to be unresponsive. The display on just the microwave is blank. The oven seems to work fine. Since the heat from the cleaning cycle vents through the microwave vents i am wondering if the fuse got too hot when the microwave was turned on a just blew. I am assuming the microwave and oven have separate fuses. If you believe it is a fuse how do i get to it to replace it. If not any suggestions.
For model number JMC8130DDS
Hello Edward, Thank you for the question. I would agree the fuse may have blown thinking the Microwave was over heating. We suggest replacing the fuse. Good luck with the repair.
1 person found this helpful.
Was this helpful?
Thank you for voting!
Earl
March 19, 2023
WILL THIS FUSE REPLACE THE BLOWN ONE I REPLACED. I WANT A SPARE.
For model number SMH8165W (SAMSUNG)
Hello Earl, thank you for your question. The fuse is located on the Noise Filter PS4239678. Thank you and have a great day.
How do i get to the fuse - my microwave is attached to the over and installed as one piece into the wall -jmc8130dds. Are there any diagrams available that shows where the fuse is and how to get it in a combo unit? I assume i am going to have to pull the whole unit out of the cabinet.
For model number JMC8130DDS
Hello and thank you for writing.
Yes, you are right, you would have to take the unit out, then take off the cabinet. You will see the fuse close to where the power cord comes in from the back of the unit, there should be a small board onto which the fuse is clipped on. We hope this information helps. Please contact us anytime if you require further assistance.
Was this helpful?
Thank you for voting!
John
October 10, 2022
This is a built-in wall unit above an oven. While the oven was being self-cleaned (hot!), the microwave was activated but went completely blank after a few seconds. I purchased the replacement ceramic breaker from you but don’t know where/how to look for the circuit breaker location in the microwave?
For model number Maytag UMC5200BAS microwave
Hello John, thank you for the question. Remove the microwave from the oven cabinet and remove the cover. The fuse is next to the capacitor behind the control panel. Always unplug your appliance before you begin any repair. We hope this helps!
Was this helpful?
Thank you for voting!
Beth
February 17, 2020
After 1-2 minutes of operating unit powers off. Have pulled out from wall and push reset switch on back of unit. Will power back on, but will shut off again after approx. 1 minute. Any suggestions on what may be causing this and if it can be fixed?
For model number JMC8130DDB
Hello and thank you for writing.
It certainly sounds like it could be a faulty capacitor PS11743000 and/or possibly faulty door switches PS373050 you should check the part(s) for signs of damage or test with a multimeter, and replace the part(s) as needed. We hope this helps. Please contact us anytime if you require further assistance.
Fresh Flow Produce Preserver is made for your refrigerator to help keep produce fresh for longer by absorbing the chemical, ethylene, that causes your fruits and vegetables to ripen quicker. Your produce could be fresh f...
This front load washer cleaner removes odor-causing residue. Use it once a month and it will keep your machine fresh and clean. Package comes with 3 tablets.
Affresh dishwasher Cleaner is specially formulated to help remove limescale and mineral build-up that can be unsightly and could affect your dishwasher's performance. Each tablet is designed to clean inside your machine ...
Make your cooktop shine with Frigidaire ReadyClean Glass and Ceramic Cleaner. Our scratch-free, streak-free formula removes smudges, grease, burnt-on food, dirt and oil, while protecting and polishing to repel dust and d...
Affresh® Dishwasher Cleaner is the #1 recommended cleaner by Whirlpool, KitchenAid, and Maytag brands, designed to remove limescale and mineral build-up that can affect your dishwasher’s performance. These powerful table...
Model Cross Reference
This part works with the following models:
PartSelect Number: PS11747931
Manufacturer Part Number: WPM0805101
