Norman from Weatherford, TX
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Parts Used:
Dishwasher would not start when Normal was selected. Would run fine if other option selected.
I began by opening the door to the dishwasher. The front panel on this unit is a custom wood panel held on by six screws. I removed the screws and the front panel. Then I unscrewed the two remaining screws holding the control panel onto the door. I also removed the two screws holding the door latch in position. With all screws removed the control panel simply slid off the top of the door. Inside the control panel, I used a small screw drive to pry the retainer clips back from the edge of the electronic control board. The control panel then snaps out. I disconnected the ribbon cable from both boards and reinstalled the new ribbon cable. I then reattached the ribbon cable to the new electronic control board and snapped the new control board into place. I reinstalled the control panel and tested the "Normal" position to insure the dishwasher would respond appropriately. After checking for proper operation, I reinstalled all screws,including the door latch and the front cover. Operation complete.
8 of 12 people found this instruction helpful.